LC87F06J2A Datasheet, PDF (5/32 Pages) Sanyo Semicon Device – CMOS IC FROM 192K byte, RAM 8192 byte on-chip 8-bit 1-chip Microcontroller

LC87F06J2A
„System Clock Divider Function
• Can run on low current.
• The minimum instruction cycle selectable from 300ns, 600ns, 1.2µs, 2.4µs, 4.8µs, 9.6µs, 19.2µs, 38.4µs, and 76.8µs
(at a main clock rate of 10MHz).
„Standby Function
• HALT mode: Halts instruction execution while allowing the peripheral circuits to continue operation.
1) Oscillation is not halted automatically.
2) Canceled by system reset or occurrence of interrupt.
• HOLD mode: Suspends instruction execution and the operation of the peripheral circuits.
1) The CF, RC, and crystal oscillators automatically stop operation.
2) There are three ways of resetting the HOLD mode.
(1) Setting the Reset pin to the lower level
(2) Setting at least one of the INT0, INT1, INT2, INT4, and INT5 pins to the specified level
(3) Having an interrupt source established at port 0
• X'tal HOLD mode: Suspends instruction execution and the operation of the peripheral circuits except the base timer
and the Day-and-time counter.
1) The CF and RC oscillators automatically stop operation.
2) The state of crystal oscillation established when the HOLD mode is entered is retained.
3) There are four ways of resetting the X'tal HOLD mode.
(1) Setting the Reset pin to the low level.
(2) Setting at least one of the INT0, INT1, INT2, INT4, and INT5 pins to the specified level.
(3) Having an interrupt source established at port 0.
(4) Having an interrupt source established in the base timer circuit.
„Onchip Debugging
• Permits software debugging with the test device installed on the target board.
„ROM Correction Function
• PC match address registers: 4
• Ram for ROM correction: 128byte
„Package Form
• QIP100E(14×20): “Lead-free type”
„Development Tools
• On-chip debugger: TCB87 TypeA + LC87F06J2A
: TCB87 TypeB + LC87F06J2A
„Flash ROM Programming Boards
Package
Programming boards
QIP100E(14×20)
W87F05256Q
„Flash ROM Programmer
Maker
Model
Flash Support Group, Inc.
(Single)
Flash Support Group, Inc.
(Gang)
SANYO
AF9708/AF9709/AF9709B
(including product of Ando Electric Co.,Ltd)
AF9723(Main body)
(including product of Ando Electric Co.,Ltd)
AF9833(Unit)
(including product of Ando Electric Co.,Ltd)
SKK(Sanyo FWS)
Supported version
Revision: After 02.61
Revision: After 02.04
Revision: After 01.86
Application Version: After 1.03
Chip Data Version: After 2.01
Device
LC87F06J2A FAST
LC87F06J2A FAST
LC87F06J2
No.A0432-5/32