LC87F06J2A Datasheet, PDF (24/32 Pages) Sanyo Semicon Device – CMOS IC FROM 192K byte, RAM 8192 byte on-chip 8-bit 1-chip Microcontroller

LC87F06J2A
Automatic transmission output characteristics
at Ta = -20°C to +70°C, VSS1 = VSS2 = VSS3 = VSS4 = VSSVCO = 0V
Parameter
Symbol
Frequency tSCK(9)
Pins/
Remarks
SCK7(PA2),
Conditions
See fig. 8.
• (Note10-1)
VDD[V]
Specification
min
typ
max
unit
4
Low level
tSCKL(9)
2
pulse width
tSCKLA(9)
2
High level
pulse width
tSCKH(9)
tSCKHA(9)
tBLKSEP(9a)
See fig. 8.
2
4.5 to 5.5
2
tCYC
• Transfer continuous data blocks
4
• (Note10-1)
tBLKSEP(9b)
See fig. 8.
• Transfer continuous data blocks with
4+
skipping S-number of data blocks
(2/3) •S
• (Note10-1)
Frequency tSCK(10)
SCK7(PA2), • CMOS output selected
26/3
• See fig. 8.
Low level
pulse width
High level
pulse width
tSCKL(10)
tSCKLA(10)
tSCKH(10)
tSCKHA(10)
• (Note10-1)
1/2
4.5 to 5.5
1/2
1/2
1.5
tSCK
Output delay
tdDO(8)
SB7(PA1)
• Must be specified with
time
respect to falling edge of SIOCLK
• Must be specified as the time to the
beginning of output state change in
4.5 to 5.5
1tCYC
µs
+0.05
open drain output mode.
• See fig. 8.
Note10-1: When starting transmission, a time from ECST begin set when serial clock is “H” to the first negative edge
of serial clock must be longer than the following.
(4 + (2/3) • S) • tCYC
S: Skipping number of data block when starting transmission.
No.A0432-24/32