LC78711E Datasheet, PDF (27/43 Pages) Sanyo Semicon Device – Graphics Display Processor

LC78711E
• Data1: DSPB
— Function: Sprite pattern B display control setting
— Operation: DSPB = 0: Sprite B display off
DSPB = 1: Sprite B display on
• Data0: DSPA
— Function: Sprite pattern A display control setting
— Operation: DSPA = 0: Sprite A display off
DSPA = 1: Sprite A display on
13. Register 0Ehex
• Data7: Unused (Must be set to 0.)
Data6: Unused (Must be set to 0.)
Data5: Unused (Must be set to 0.)
Data4: Unused (Must be set to 0.)
Data3: Unused (Must be set to 0.)
Data2: Unused (Must be set to 0.)
Data1: Unused (Must be set to 0.)
• Data0: SROENM
— Function: Output signal setting for the PSC1 pin (pin 12)
— Operation: Controls whether or not the serial output data setup complete flag is output from the PCS1 pin.
SROENM = 0: The flag is not output.
SROENM = 1: The flag is output.
14. Register 0Fhex
• Data7: Unused (Must be set to 0.)
Data6: Unused (Must be set to 0.)
Data5: Unused (Must be set to 0.)
Data4: Unused (Must be set to 0.)
• Data3: CRSM
— Function: Output signal setting for the PSC2 pin (pin 13)
— Operation: Controls whether or not the PSC2 pin output monitors the cross cursor display state.
CRSM = 0: The cursor state is not monitored.
CRSM = 1: The cross cursor display state is monitored.
A high level is output when the cross cursor is displayed.
No. 5476-27/43