LC86P6032 Datasheet, PDF (2/22 Pages) Sanyo Semicon Device – 8-Bit Single Chip Microcontroller with One-Time PROM

Notice for use
When using, please take note of the following.
LC86P6032
(1) Differences between the LC86P6032 and the LC866000 series
Item
LC86P6032
LC866032/28/24/20/16/12/08
Port status at reset
Please refer to “Port status at reset” on the next page.
Operation after releasing The option is specified by degrees within The program located at 00H is executed
reset
3ms after applying a ‘H’ level to the reset immediately after applying a ‘H’ level to
pin.
the reset pin.
The program located at 00H is
executed.
Output form of segment
Pulldown resistor
Pulldown resistor : Provided/Not provided
•S0/T0 to S6/T6
Not provided
Specified by the option
•S7/T7 to S15/T15
Provided(fixed)
Provided(fixed)
•S16 to S23
Provided(fixed)
Specified by the option
•S24 to S29
Not provided
Specified by the option
Operating supply
4.5V to 6.0V
2.5V to 6.0V
voltage range (VDD)
Power dissipation
Refer to “electrical characteristics” on the semiconductor news.
LC86P6032 uses 256 bytes that is addressed on 7F00H to 7FFFH in the program memory as the option
configuration data area. This option configuration cannot execute all options which LC866000 series have. Next
tables show the options that correspond and not correspond to LC86P6032.
• LC86P6032 Options
Option
Configuration of input/output ports
Port 7 pull-up MOS transistor
Pins, Circuits
Port 0
(Can be specified for
each bit.)
Port 1
(Can be specified for
each bit.)
Port 7
(Can be specified for
each bit.)
Option Settings
1. Input : No pull-up MOS transistor
Output : N-channel open drain
2. Input : Pull-up MOS transistor
Output : CMOS
1. Input : Programmable pull-up MOS transistor
Output : N-channel open drain
2. Input : Programmable Pull-up MOS transistor
Output : CMOS
1. Pull-up MOS transistor not provided.
2. Pull-up MOS transistor provided.
• A kind of option not corresponding LC86P6032
Option
Pins, Circuits
Pull-down resistor of high ·S0/T0 to S6/T6
voltage withstand output ·S16 to S23
terminal
·S24 to S29
(specified in a bit)
LC86P6032
Not provided
Provided(fixed)
Not provided
LC866032/28/24/20/16/12/08
Specified by the option
Specified by the option
Specified by the option
The port operation related to the option is different at reset. Please refer to the next table.
No.4212-2/22