LC86P6032 Datasheet, PDF (10/22 Pages) Sanyo Semicon Device – 8-Bit Single Chip Microcontroller with One-Time PROM

LC86P6032
1. Absolute Maximum Ratings at VSS=0V and Ta=25°C
Parameter
Symbol
Pins
Ratings
Conditions
unit
VDD[V] min. typ. max.
Supply voltage VDDMAX VDD,VDDVPP
-0.3
+7.0
V
Input voltage
VI(1)
•Ports 71,72,3,8
-0.3
VDD+0.3
• RES
VI(2)
VP
VDD-4.5
VDD+0.3
Output voltage
VO
•S0/T0 to S15/T15
VDD-4.
VDD+0.3
•S16 to S29
5
Input/Output
VIO
•Ports 0, 1
-0.3
VDD+0.3
voltage
•Port 70
High Peak IOPH(1) Ports 0, 1
•CMOS output
-4
mA
level output
•At each pin
output current IOPH(2) S0/T0 to S15/T15 •At each pin
-30
current
IOPH(3) S16 to S29
•At each pin
-15
Total ∑IOAH(1) Port 0
Total of all pins
-10
output ∑IOAH(2) Port 1
Total of all pins
-10
current _{∑IOAH(3) •S0/T0 to S15/T15 Total of all pins}
-130
•S16 to S29
Low Peak IOPL(1) Ports 0, 1
At each pin
20
level output IOPL(2) Port 70
At each pin
15
output current
current Total ∑IOAL(1) Port 0
Total of all pins
40
output ∑IOAL(2) Ports 1, 70
Total of all pins
40
current
Power dissipation Pdmax(1) DIP64S
Ta=-30 to+70°C
760 mW
(max.)
Pdmax(2) QFP64E
Ta=-30 to+70°C
430
Operating
Topr
-30
+70
°C
temperature range
Storage
Tstg
-65
+150
temperature range
Notes
• The QFP packages should be heat-soaked for 24 hours at 125°C immediately prior to mounting (This baking is called
pre-baking).
• After pre-baking, a controlled environment must be maintained until soldering. The environment must be held at a
temperature of 30°C or less and a humidity level of 70% or less. Please solder within 8 hours.
No.4212-10/22