LC86P6032 Datasheet, PDF (14/22 Pages) Sanyo Semicon Device – 8-Bit Single Chip Microcontroller with One-Time PROM

LC86P6032
Parameter
Output off-
leakage
current
Pull-down
resistor
Hysteresis
voltage
Pin
capacitance
Symbol
Pins
Conditions
Ratings
unit
VDD[V] min. typ. max.
IOFF(1) S0/T0 to S6/T6, •Output P-ch Tr. OFF 4.5 to 6.0 -1
µA
S24 to S29 without •VOUT=VSS
IOFF(2) pull-down resistor •Output P-ch Tr. OFF 4.5 to 6.0 -30
•VOUT=VDD-40V
Rpd
S7/T7 to S15/T15, •Output P-ch Tr. OFF 5.0
60
100 200 KΩ
S16 to S23 with •VOUT=3V
pull-down resistor •Vp=-30V
VHIS
•Ports 0, 1
Output disable
4.5 to 6.0
0.1VDD
V
•Port 7
• RES
CP
All pins
•f=1MHz
4.5 to 6.0
10
pF
•Unmeasured input
pins are set to
VSS level
•Ta=25°C
4. Serial Input/Output Characteristics at Ta=-30°C to +70°C, VSS=0V
Parameter
Cycle
Low-level
pulse width
High-level
pulse width
Cycle
Low-level
pulse width
High-level
pulse width
Data set up time
Data hold time
Output delay time
(Serial clock is
external clock)
Output delay time
(Serial clock is
internal clock)
Symbol
Pins
tCKCY(1) SCK0,
tCKL(1) SCK1
Conditions
Refer to figure 5.
VDD[V] min.
4.5 to 6.0 2
4.5 to 6.0 1
Ratings
typ.
max.
unit
tCYC
tCKH(1)
4.5 to 6.0 1
tCKCY(2) SCK0,
tCKL(2) SCK1
tCKH(2)
•Use pull-up
4.5 to 6.0 2
resistor (1kΩ)
4.5 to 6.0
when set to open-
drain output.
4.5 to 6.0
•Refer to figure 5.
1/2
tCKCY
1/2
tCKCY
tICK
•SI0,SI1 •Data set-up to
4.5 to 6.0 0.1
µs
•SB0,SB1 SCK0,1
•Data hold from
tCKI
SCK0,1
4.5 to 6.0 0.1
•Refer to figure 5.
tCKO(1) •SO0,SO1 •Use pull-up
4.5 to 6.0
7/12
•SB0,SB1 resistor (1kΩ)
tCYC
when set to open-
+0.2
drain output.
tCKO(2)
•Data hold from
SCK0,1
•Refer to figure 5.
4.5 to 6.0
1/3
tCYC
+0.2
No.4212-14/22