K4T1G044QC Datasheet, PDF (12/26 Pages) Samsung semiconductor – 1Gb C-die DDR2 SDRAM Specification

K4T1G044QC
K4T1G084QC
DDR2 SDRAM
7.6 Differential input AC logic Level
Symbol
VID(AC)
VIX(AC)
Note :
Parameter
AC differential input voltage
AC differential cross point voltage
Min.
0.5
0.5 * VDDQ - 0.175
Max.
VDDQ + 0.6
0.5 * VDDQ + 0.175
Units
V
V
Notes
1
2
1. VID(AC) specifies the input differential voltage |VTR -VCP | required for switching, where VTR is the true input signal (such as CK, DQS, LDQS or UDQS)
and VCP is the complementary input signal (such as CK, DQS, LDQS or UDQS). The minimum value is equal to V IH (AC) - V IL(AC).
2. The typical value of VIX(AC) is expected to be about 0.5 * VDDQ of the transmitting device and VIX(AC) is expected to track variations in VDDQ .
VIX(AC) indicates the voltage at which differential input signals must cross.
V_TR
V_CP
V_DDQ
V_ID
Crossing point
V_{IX or} V_OX
V_SSQ
< Differential signal levels >
7.7 Differential AC output parameters
Symbol
Parameter
Min.
Max.
Units
Note
V_OX(AC) _{AC differential cross point voltage}
0.5 * VDDQ - 0.125
0.5 * VDDQ + 0.125
V
1
Note :
1. The typical value of VOX(AC) is expected to be about 0.5 * VDDQ of the transmitting device and VOX(AC) is expected to track variations in VDDQ .
VOX(AC) indicates the voltage at which differential output signals must cross.
8.0 ODT DC electrical characteristics
PARAMETER/CONDITION
Rtt effective impedance value for EMRS(A6,A2)=0,1; 75 ohm
Rtt effective impedance value for EMRS(A6,A2)=1,0; 150 ohm
Rtt effective impedance value for EMRS(A6,A2)=1,1; 50 ohm
Deviation of VM with respect to VDDQ/2
SYMBOL
Rtt1(eff)
Rtt2(eff)
Rtt3(eff)
delta VM
MIN NOM MAX UNITS NOTES
60
75
90
ohm
1
120
150
180
ohm
1
40
50
60
ohm
1
-6
+6
%
1
Note1: Test condition for Rtt measurements
Measurement Definition for Rtt(eff): Apply V_IH (ac) and V_IL (ac) to test pin separately, then measure current I(V_IH (ac)) and I( V_IL (ac)) respectively. V_IH
(ac), V_IL (ac), and VDDQ values defined in SSTL_18
V_IH (ac) - V_IL (ac)
Rtt(eff) =
I(V_IH (ac)) - I(V_IL (ac))
delta VM =
2 x Vm
- 1 x 100%
VDDQ
Measurement Definition for VM: Measure voltage (VM) at test pin (midpoint) with no load.
12 of 26
Rev. 1.1 June 2007