SH74593_15 Datasheet, PDF (35/38 Pages) Renesas Technology Corp – RENESAS MCU

SH74593
Appendix J
Appendix J.3
Section 38 Electrical Characteristics
38.3 AC Characteristics
• The timing conditions without specifications are the following :
Vdd = 1.5 V + 0.15 V, -0.1 V, Vcc = PLLVcc = 5.0 V ±0.5 V/3.3 V ±0.3 V, AVcc = 5.0 V ±0.5 V/3.3 V ±0.3 V,
AVREFH = 4.5 V to AVcc/3.0 V to AVcc,
Vss = PLLVss = AVss = AVREFL = 0 V, Ta = -40°C to +105°C
When not otherwise specified, the input threshold value is the value under conditions where all module input pins
for the same channel are set to the same characteristics. When not otherwise specified, the output driving ability is
the value under conditions where all module output pins for the same channel are set to the same characteristics.
• Standard values are guaranteed when the output load capacity of the measurement pin is 15 pF to 50 pF. Note that
the output load capacity of the CLKOUT pin is 15pF to 30pF.
Measured pin
CL : CLKOUT pin = 15 pF to 30 pF
: Other than the above = 15 pF to 50 pF
CMOS output
Figure 38.1 Measurement Circuit for Output Switching Characteristics
CMOS input
0.8 Vcc
0.2 Vcc
Figure 38.2 Input Waveform and Timing Check Points at Characteristics Measurement
CMOS output
0.8 Vcc
0.2 Vcc
Note: • For details on CLKOUT output timing check points at characteristics measurement,
refer to each figure in this section.
Figure 38.3 Output Timing Check Points at Characteristics Measurement
R01DS0186EJ0120 Rev.01.20
Sep 10, 2012
Page 35 of 35