MN103LF66 Datasheet, PDF (10/102 Pages) Panasonic Semiconductor – 32-bit Single-chip Microcontroller

MN103LF66/67/68/69/70/71/72/73/74/75/76/77/78/79 Series
32-bit Single-chip Microcontroller
PubNo. 2347901-012E
Serial 5, 6, 7, 8 (UART / Clock Synchronous)
- UART
Parity check, overrun error/frame error detection.
Transfer size can be selected from 7 to 8 bits.
- Clock Synchronous
The communication type can be selected from 2-wire or 3-wire.
(Data input from SBO pin is prohibited)
First tansfer bit can be selected from MSB or LSB.
Continuous transmission, continuous reception, continuous transmission/reception are available.
Arbitrary size of 7 to 8 bits are selectable.
(When selection size is 7 bits, first transfer bit setting is LSB only.)
Maximum transfer rate: 3.3 Mbps
Clock source: Output of timer A, B, C, D, E divided by 2, 16, External clock
IIC 0 to 7 (Multi master IIC)
- Multi master IIC
100 kHz/ 400 kHz communication is supported.
7-bit, 10-bit slave address is settable.
General call communication mode is supported.
Clock source
: Baud Rate Timer BIn output (n=0 to 7), external clock
A/D converter
Resolution : 10 bit
Channel : 32 channels
Clock source : clkbus/2, clkbus/4, clkbus/8, clkbus/16, clksx  2
D/A converter
Resolution
Unit
: 10-bit
: 2 units
Auto reset
Auto reset function can be selected ON/OFF
Power supply voltage detection circuit
Detection voltage can be set 2.6 V to 4.0 V by software
Clock monitoring function
Frequency error detection of CPU clock when external / PLL clock is used as clock source
Hardware reset or non-maskable interrupt generation can be selected by program when a frequency
error is detected.
Publication date: November 2015