AMIS-49587_P2 Datasheet, PDF (4/55 Pages) ON Semiconductor – Power Line Carrier Modem

AMIS--49587
2 ABSOLUTE MAXIMUM RATINGS2.1
Stresses above those listed in this clause may cause permanent device failure. Exposure to absolute maximum ratings for
extended periods may affect device reliability.
2.1.1 Power Supply Pins VDD, VDDA, VSS, VSSA
Table 2. ABSOLUTE MAXIMUM RATINGS SUPPLY
Rating
Symbol
Min
Max
Unit
Absolute maximum digital power supply
V_{DD_ABSM}
V_SS--0.3
3.9
V
Absolute maximum analog power supply
V_{DDA_ABSM}
V_SSA--0.3
3.9
V
Absolute maximum difference between digital and analog power supply
V_DD--V_{DDA_ABSM}
--0.3
0.3
V
Absolute maximum difference between digital and analog ground
V_SS--V_{SSA_ABSM}
--0.3
0.3
V
Stresses exceeding Maximum Ratings may damage the device. Maximum Ratings are stress ratings only. Functional operation above the
Recommended Operating Conditions is not implied. Extended exposure to stresses above the Recommended Operating Conditions may affect
device reliability.
2.1.2 Non 5V Safe Pins: TX_OUT, ALC_IN, RX_IN, RX_OUT, REF_OUT, M50HZ_IN, XIN, XOUT, TDO, TDI, TCK, TMS,
TRSTB, TEST
Table 3. ABSOLUTE MAXIMUM RATINGS NON 5V SAFE PINS
Rating
Symbol
Min
Max
Unit
Absolute maximum input for normal digital inputs and analog inputs
Absolute maximum voltage at any output pin
V_{IN_ABSM}
V_{OUT_ABSM}
V_SS*--0.3 V_DD*+0.3
V
V_SS*--0.3 V_DD*+0.3
V
2.1.3 5V Safe Pins: TX_ENB, TXD, RXD, BR0, BR1, RESB, RX_DATA, TREQ, CRC, TX_DATA/PRE_SLOT
Table 4. ABSOLUTE MAXIMUM RATINGS 5V SAFE PINS
Rating
Symbol
Min
Max
Unit
Absolute maximum input for digital 5 V safe inputs
Absolute maximum voltage at 5 V safe output pin
V_{5VS_ABSM}
V_SS--0.3
6.0
V
V_{OUT5V_ABSM}
V_SS--0.3
3.9
V
2.2 Normal Operating Conditions
Operating ranges define the limits for functional operation and parametric characteristics of the device as described in the
Receiver Block Diagram Section and for the reliability specifications as listed in the Local Transfer and Configuration
Commands (LTC) Section. Functionality outside these limits is not implied.
Total cumulative dwell time outside the normal power supply voltage range or the ambient temperature under bias, must
be less than 0.1% of the useful life as defined in the Local Transfer and Configuration Commands (LTC) Section.
Table 5. OPERATING RANGES
Rating
Power Supply Voltage Range
Ambient Temperature
Symbol
V_DD
T_A
Min
Max
Unit
3.0
3.6
V
--25
70
°C
http://onsemi.com
4