English
Language : 

TCC-206 Datasheet, PDF (30/33 Pages) ON Semiconductor – Six-Output PTIC Control IC
TCC−206
Bit 2: Trigger 2
Write 1 to this bit, to move data from shadow registers into destination register. This trigger can be
masked by bit 5.
Bit 1: Trigger 1
Write 1 to this bit, to move data from shadow registers into destination register. This trigger can be
masked by bit 4.
Bit 0: Trigger 0
Write 1 to this bit, to move data from shadow registers into destination register. This trigger can be
masked by bit 3.
All three triggers from register [0x1C] behave in the same way as the external pin TRIG. When each of these triggers is set
using the MIPI RFFE interface the results are the same as when an active voltage level is applied to the TRIG pin when External
pin TRIG is selected.
Register RFFE:
RFFE_PRODUCT_ID_0x1D
Reset Source: N/A
Address RFFE A[4:0]:
0x1D
Bits
Reset
7
6
5
4
3
2
1
PID7
PID6
PID5
PID4
PID3
PID2
PID1
0
0
1
0
0
1
OTP[4]
Bits [7:2] are hardcoded in ASIC
Bits [1:0] can be programmed in OTP during manufacturing
The MIPI register RFFE_PRODUCT_ID can be read in SPI mode as described in 6.9.5
0
PID0 (1)
IDB0 pin
Register RFFE:
RFFE_MANUFACTURER_ID_0x1E
Reset Source: N/A
7
6
5
Bits
MPN7
MPN6
MPN5
Reset
0
0
1
4
MPN4
0
Address RFFE A[4:0]:
0x1E
3
MPN3
1
2
MPN2
1
1
MPN1
1
0
MPN0
0
Register RFFE:
RFFE_USID_0x1F
Address RFFE A[4:0]:
0x1F
Reset Source: nreset_dig or PWR_MODE = ‘01’ (transition through STARTUP mode)
7
6
5
4
3
2
1
0
Bits
Reserved (2)
MPN9 (2) MPN8 (2) USID3 (1) USID2 (1) USID1 (1)
USID0 (1)
Reset
0
0
0
1
W−0
W−1
W−1
W−1
USID = Unique Slave Identifier Register
(1) USID field can be changed by:
•
MIPI−RFFE broadcast messages when USID field within the Register Write Command is
0b0000
•
MIPI−RFFE individual messages when USID field within the Register Write Command
equal with content of RFFE_REG_0x1F[3:0]
(2) In the sequence of writing USID field, the upper [7:4] must match the value 0b0001 hard−coded in
the RFFE register 0x1F
NOTE: USID value is NOT retained during SHUTDOWN power mode.
NOTE: USID value is not affected by SWR bit from RFFE_STATUS register DAC Update
www.onsemi.com
30