AMIS-30622_13 Datasheet, PDF (28/50 Pages) ON Semiconductor – I2C Micro-Stepping Motor Driver

AMIS−30622
Table 19. RAM REGISTERS
Register
Length
Mnemonic (bit)
Related Commands
Comment
Reset
State
Actual position
ActPos
16 GetFullStatus2
GotoSecurePos
ResetPosition
16−bit signed
Last programmed
Position
Pos/TagPos
16/11
GetFullStatus2
GotoSecurePos
ResetPosition
SetPosition
16−bit signed or
11−bit signed for half stepping
(see Positioning)
Acceleration shape
AccShape
1 GetFullStatus1
SetMotorParam
ResetToDefault
‘0’ ⇒ normal acceleration from Vmin to Vmax
‘0’
‘1’ ⇒ motion at Vmin without acceleration
Coil peak current
Irun
4 GetFullStatus1
Operating current
SetMotorParam
See look−up table Irun
ResetToDefault
Coil hold current
Ihold
4 GetFullStatus1
SetMotorParam
ResetToDefault
Standstill current
See look−up table Ihold
Minimum Velocity
Vmin
4 GetFullStatus1
SetMotorParam
ResetToDefault
See Section Minimum Velocity
See look−up table Vmin
Maximum Velocity
Shaft
Vmax
Shaft
4 GetFullStatus1
SetMotorParam
ResetToDefault
1 GetFullStatus1
SetMotorParam
ResetToDefault
See Section Maximum Velocity
See look−up table Vmax
Direction of movement
From
OTP
memory
Acceleration/
deceleration
Acc
4 GetFullStatus1
See Section Acceleration
SetMotorParam
See look−up table Acc
ResetToDefault
Secure Position
SecPos
11 GetFullStatus2
SetMotorParam
ResetToDefault
Target position when HW connection fails; 11
MSB’s of 16−bit position (LSB’s fixed to ‘0’)
Stepping mode
StepMode
2 GetFullStatus1
SetStallParam
ResetToDefault
See Section Stepping Modes
See look−up table StepMode
28. A ResetToDefault command will act as a reset of the RAM content, except for ActPos and TagPos, which are registers that are not
modified. Therefore, the application should not send a ResetToDefault during a motion, to avoid any unwanted change of parameter.
http://onsemi.com
28