AMIS-30623 Datasheet, PDF (22/65 Pages) AMI SEMICONDUCTOR – LIN Microstepping Motordriver

AMIS-30623
DriveHS
Tsw =1024 μs
512 μs
t
Tsw_on = 128 μs
DriveLS
t
"R"-Comp
R_th
t
SWI_Cmp
120 μs
t
ESW
0
1
1
1
t
ActPos
t
Figure 15: Timing Diagram Showing the Change in States for SWI comparator
14.2 Main Control and Register, OTP Memory + ROM
14.2.1. Power-up Phase
Power up phase of the AMIS-30623 will not exceed 10ms. After this phase, the AMIS-30623 is in shutdown mode, ready to receive LIN
messages and execute the associated commands. After power-up, the registers and flags are in the reset state, some of them being
loaded with the OTP memory content (see Table 19).
14.2.2. Reset State
After power-up, or after a reset occurrence (e.g. a micro cut on pin VBB has made Vdd to go below VddReset level), the H-bridges will
be in high impedance mode, and the registers and flags will be in a predetermined position. This is documented in Table 19 and Table
20.
14.2.3. Soft Stop
A soft stop is an immediate interruption of a motion, but with a deceleration phase. At the end of this action, the register TagPos is
loaded with the value contained in register ActPos to avoid an attempt of the circuit to achieve the motion (see Table 19). The circuit is
then ready to execute a new positioning command, provided thermal and electrical conditions allow for it.
Rev. 4 | Page 22 of 65 | www.onsemi.com