S8VS-03024 Datasheet, PDF (27/38 Pages) Omron Electronics LLC – Switch Mode Power Supply

S8VS
Peak Hold Current Reset
The peak value of the output current (i.e., the peak hold current) can
be reset on the display.
Operation mode
Key Press 3 seconds or more.
Reset
Peak hold current
value measurement
starts
2 seconds (Peak hold current will be displayed
2 seconds after it is reset.)
Note: The peak hold current value is not reset in the setting mode.
Undervoltage Alarm Indication
This indicator lights when the output voltage lowers.
Operation
Mode
Undervoltage occurs.
Undervoltage
alarm
Output
current
*
Output voltage lower limit
*This indicator alternately
displays alarm ( ) and
the output voltage lower
limit.
Multiple Alarms
When two or more different alarms occur at the same time
Operation
Mode
Undervoltage
alarm
Maintenance
forecast
monitor
(See note.)
The indication shifts
alternately in the direction
of the arrow every 2 s.
(See note.)
* When undervoltage alarm is indicated: Press Key → output
load indication
When the maintenance forecast monitor or overheat alarm is
indicated: Press Key → undervoltage alarm indication
Note: 1. The above displays are for models with a maintenance
forecast monitor (S8VS-@@@24A@@).
Peak-hold
current
Maintenance
forecast
monitor
Note: 1. When the voltage is restored to the set value or higher and
the Key is pressed at the a01 display to return to the
output current display, the a01 alarm will be cleared and the
normal output display will return.
2. The above displays are for models with a maintenance
forecast monitor (S8VS-@@@24A@@).
27