S8VS-03024 Datasheet, PDF (26/38 Pages) Omron Electronics LLC – Switch Mode Power Supply

S8VS
Display and Alarm Output Functions and Operating Procedures
S8VS-@@@24A@@ models (with display monitor) can display the output voltage, output current, peak hold current, or maintenance forecast
monitor time. S8VS-@@@24B@@/S8VS-@@@24BE@ models (with display monitor) can display the output voltage, output current, peak hold
current, or total run time.
Mode Change
Power-ON
Model indication
Operation mode
Press and hold
Up key U or Down Key D
for three seconds or more.
Press Mode key and
hold for three seconds or more.
Or no key operation for 30 seconds or more.
Setting mode
Note: No setting mode is provided for the S8VS-06024@.
Operation Mode
Various states of the Power Supply are indicated.
Models with Maintenance Forecast Monitor (S8VS-@@@24A@@)
Models with Total Run Time Monitor (S8VS-@@@24B@@/
S8VS-@@@24BE@)
Output voltage
(Voltage output by Power Supply is
monitored and displayed.)
Output current
(Current output by Power Supply is
monitored and displayed.)
Peak hold current (See note 1.)
(Maximum current output by Power Supply is
recorded and displayed.)
Maintenance forecast monitor
Output voltage
(Voltage output by Power Supply is
monitored and displayed.)
Output current
(Current output by Power Supply is
monitored and displayed.)
Peak hold current
(Maximum current output by Power Supply is
recorded and displayed.)
Total run time monitor
Note: 1. The peak hold current starts measuring the current 3 seconds after the Power Supply is started. Inrush current is thus not measured.
2. For the factory setting, the output voltage will be displayed when the power supply is first turned ON. Thereafter, the output voltage will
be indicated in the same display when shutting down.
Setting Mode (Except for S8VS-06024@)
Set various parameters of the Power Supply.
Models with Maintenance Forecast Monitor (S8VS-@@@24A@@)
Models with Total Run Time Monitor (S8VS-@@@24B@@/S8VS-@@@24BE@)
Operation Mode
or
Press 3 seconds
or more.
Press 3 seconds or more or no key
pressed for 30 seconds or more.
Operation Mode
or
Press 3 seconds
or more.
Press 3 seconds or more or no key
pressed for 30 seconds or more.
Undervoltage
detected
/
*
18.5 to 20.0 to 27.5 (V)
0.1-V steps
Undervoltage
detected
/
*
18.5 to 20.0 to 27.5 (V)
0.1-V steps
Maintenance
forecast
/
*
0.0 to 0.5 to 5.0 (y)
0.5-year steps
Total run
time
/
*
1 to 50 to 150 ( × 1000 h)
1,000-hour steps
* Factory settings are in reverse
* Factory settings are in
type.
reverse type.
Note: 1. Press and hold the (9) Up Key U or (10) Down Key D for two seconds or more to increase or decrease the value rapidly.
2. The S8VS-06024@ is not provided with the setting mode and its parameters are fixed at the shipment setting.
26