COP410L Datasheet, PDF (4/20 Pages) National Semiconductor (TI) – Single-Chip N-Channel Microcontrollers

COP310L COP311L
Absolute Maximum Ratings
If Military Aerospace specified devices are required
please contact the National Semiconductor Sales
Office Distributors for availability and specifications
Voltage at Any Pin Relative to GND
b0 5V to a10V
Ambient Operating Temperature
b40 C to a85 C
Ambient Storage Temperature
b65 C to a150 C
Lead Temperature
(Soldering 10 seconds)
300 C
Power Dissipation
COP310L
COP311L
0 75W at 25 C
0 25W at 85 C
0 65W at 25 C
0 20W at 85 C
Total Source Current
120 mA
Total Sink Current
100 mA
Note Absolute maximum ratings indicate limits beyond
which damage to the device may occur DC and AC electri-
cal specifications are not ensured when operating the de-
vice at absolute maximum ratings
DC Electrical Characteristics b40 C ^s T_A ^s a85 C 4 5V ^s V_CC ^s 5 5V unless otherwise noted
Parameter
Conditions
Min
Max
Units
Standard Operating Voltage (V_CC)
Power Supply Ripple (Notes 1 4)
Peak to Peak
45
55
V
05
V
Operating Supply Current
All Inputs and Outputs Open
8
mA
Input Voltage Levels
Ceramic Resonator Input (d8)
Crystal Input
Logic High (V_IH)
Logic High (V_IH)
Logic Low (V_IL)
Schmitt Trigger Input (d4)
Logic High (V_IH)
Logic Low (V_IL)
RESET Input Levels
Logic High
Logic Low
V_CC e Max
V_CC e 5V g5%
(Schmitt Trigger Input)
30
V
22
V
b0 3
03
V
0 7 V_CC
V
b0 3
04
V
0 7 V_CC
V
b0 3
04
V
SO Input Level (Test Mode)
(Note 2)
22
25
V
All Other Inputs
Logic High
Logic High
Logic Low
Logic High
Logic Low
V_CC e Max
30
V
With TTL Trip Level Options
22
V
Selected V_CC e 5V g5%
b0 3
06
V
With High Trip Level Options
36
V
Selected
b0 3
12
V
Input Capacitance (Note 4)
7
pF
Hi-Z Input Leakage
b2
a2
mA
Output Voltage Levels
LSTTL Operation
Logic High (V_OH)
Logic Low (V_OL)
CMOS Operation (Note 3)
Logic High
Logic Low
V_CC e 5V g10%
I_OH e b20 mA
I_OL e 0 36 mA
I_OH e b10 mA
I_OL e a10 mA
27
V
04
V
V_CC b 1
V
02
V
Note 1 V_CC voltage change must be less than 0 5V in a 1 ms period to maintain proper operation
Note 2 SO output ‘‘0’’ level must be less than 0 6V for normal operation
Note 3 TRI-STATE and LED configurations are excluded
Note 4 This parameter is only sampled and not 100% tested Variation due to the device included
4