MC9S12DJ64 Datasheet, PDF (93/126 Pages) Motorola, Inc – MC9S12DJ64 Device User Guide V01.17

MC9S12DJ64 Device User Guide — V01.17
A.1.10.1 Measurement Conditions
All measurements are without output loads. Unless otherwise noted the currents are measured in single
chip mode, internal voltage regulator enabled and at 25MHz bus frequency using a 4MHz oscillator in
Colpitts mode. Production testing is performed using a square wave signal at the EXTAL input.
A.1.10.2 Additional Remarks
In expanded modes the currents flowing in the system are highly dependent on the load at the address, data
and control signals as well as on the duty cycle of those signals. No generally applicable numbers can be
given. A very good estimate is to take the single chip currents and add the currents due to the external
loads.
Table A-7 Supply Current Characteristics
Conditions are shown in Table A-4 unless otherwise noted
Num C
Rating
Symbol Min
1
P
Run supply currents
Single Chip, Internal regulator enabled
Wait Supply current
2P
P
All modules enabled, PLL on
only RTI enabled ¹
I_DD5
I_DDW
Pseudo Stop Current (RTI and COP disabled) ^{1, 2}
C
-40°C
P
27°C
C
70°C
3
C
P
85°C
"C" Temp Option 100°C
I_DDPS
C
105°C
P
"V" Temp Option 120°C
C
125°C
P
"M" Temp Option 140°C
Pseudo Stop Current (RTI and COP enabled) ^{1, 2}
C
-40°C
C
27°C
4
C
C
70°C
85°C
I_DDPS
C
105°C
C
125°C
C
140°C
Stop Current ²
C
P
C
5
C
P
C
P
C
P
-40°C
27°C
70°C
85°C
"C" Temp Option 100°C
I_DDS
105°C
"V" Temp Option 120°C
125°C
"M" Temp Option 140°C
Typ
370
400
450
550
600
650
800
850
1200
570
600
650
750
850
1200
1500
12
25
100
130
160
200
350
400
600
Max
50
30
5
Unit
mA
mA
500
1600
µA
2100
5000
µA
100
1200
µA
1700
5000
93