455600161 Datasheet, PDF (18/27 Pages) Molex Electronics Ltd. – 0.8MM HANDYLINK 16 CKT CRADLE CONN. ASSY PERPENDICULAR TO PCB

HANDYLINK™
APPLICATION SPECIFICATION
6.4.1 Plug Over-Mold Designs
Supplemental guide features to align the connectors during mating or un-mating are strongly recommended if any of the following
conditions are present:
o A great deal of curvature in the end product (such as that illustrated, below);
o The accessory cable is stiff or bent abruptly;
o The mass of the end-product itself is greater than 1000grams and is likely to experience more than 1g of acceleration during use or
under vibration;
o The cable connection and disconnection cycles are numerous (more than 5000 cycles);
o There is significant risk of the end users pulling at connections in off-axis directions.
Figure 12. Example of an application
with a great degree of curvature near
the connector interface.
Supplemental guide features may be incorporated into or complement the over-mold design as illustrated in Figures 12 and 13:
18_REVISION:
ECR/ECN INFORMATION:
B
EC No: UCP2009-1982
DATE: 2009/02/09
DOCUMENT NUMBER:
SD-45560-002
TITLE:
APPLICATION SPECIFICATION
HANDYLINK™I/O CONNECTOR SYSTEM
SHEET No.
18 of 27
CREATED / REVISED BY:
M. Simmel/D. Morgan
CHECKED BY:
M. Ibarra
APPROVED BY:
S. Miller
TEMPLATE FILENAME: PRODUCT_SPEC[SIZE_A](V.1).DOC