455600161 Datasheet, PDF (11/27 Pages) Molex Electronics Ltd. – 0.8MM HANDYLINK 16 CKT CRADLE CONN. ASSY PERPENDICULAR TO PCB

HANDYLINK™
APPLICATION SPECIFICATION
Figure 3B. Receptacle Connector Recess When Mating with the Plug or Cradle Connectors (units: mm)
Wherever possible, the 0.10 maximum clearance condition with the receptacle should be minimized by utilizing a clam-shell style
package design.
6.1.2 Plug Connector Module
The plug connector module is intended to be used as a part of a assembly using either direct wire soldering (45339) or using an
intermediary PCB (45593). Overmolding and/or clam shell style covers must be used to protect the wire connections and the
appropriate service loops and wire strain reliefs must be incorporated in a cable assembly to prevent damage during use. Please refer
to section 6.3 for further details about the over-molding process.
If the connector module is used as a stand-alone component on a PCB, the mating interface must be adequately supported. Please
refer to section 6.4.2 for further details concerning cradle design recommendations.
6.1.3 Cradle Connector
The cradle connector is designed to be fastened to the PCB with screws. See Sales Drawings for recommended screw size and
positions. Please refer to section 6.4.2 for further details concerning cradle design recommendations.
11_REVISION:
ECR/ECN INFORMATION:
B
EC No: UCP2009-1982
DATE: 2009/02/09
DOCUMENT NUMBER:
SD-45560-002
TITLE:
APPLICATION SPECIFICATION
HANDYLINK™I/O CONNECTOR SYSTEM
SHEET No.
11 of 27
CREATED / REVISED BY:
M. Simmel/D. Morgan
CHECKED BY:
M. Ibarra
APPROVED BY:
S. Miller
TEMPLATE FILENAME: PRODUCT_SPEC[SIZE_A](V.1).DOC