455600161 Datasheet, PDF (13/27 Pages) Molex Electronics Ltd. – 0.8MM HANDYLINK 16 CKT CRADLE CONN. ASSY PERPENDICULAR TO PCB

HANDYLINK™
APPLICATION SPECIFICATION
6.3 Plug Cable Over-Molding
6.3.1 Wire Soldering
This section provides an outline of the recommended plug cable over-molding practices
for the 45339 and 45593 plug connector modules. The 45339 connector (a 16-circuit wire termination version) is shown, below, prior to
soldering. Please note the following features:
Latch soldertails (2 places)
Wire soldertails (2 rows)
Cavities under the latches (2 places)
Figure 5. Soldertail side of the plug connector
Pre-tinned wires should be terminated to the appropriate solder tails working in sequence and one row at a time, taking care that
the insulation does not become exposed more than 1mm from the end of the terminals. The completed assembly after soldering of
the wires is shown below. Dressing of the wires should be avoided until after the soldering and encapsulation processes are
complete.
13_REVISION:
ECR/ECN INFORMATION:
B
EC No: UCP2009-1982
DATE: 2009/02/09
DOCUMENT NUMBER:
SD-45560-002
TITLE:
APPLICATION SPECIFICATION
HANDYLINK™I/O CONNECTOR SYSTEM
SHEET No.
13 of 27
CREATED / REVISED BY:
M. Simmel/D. Morgan
CHECKED BY:
M. Ibarra
APPROVED BY:
S. Miller
TEMPLATE FILENAME: PRODUCT_SPEC[SIZE_A](V.1).DOC