M37270MF Datasheet, PDF (81/94 Pages) Mitsubishi Electric Semiconductor – SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER and ON-SCREEN DISPLAY CONTROLLER

MITSUBISHI MICROCOMPUTERS
M37270MF-XXXSP
M37270EF-XXXSP, M37270EFSP
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER
and ON-SCREEN DISPLAY CONTROLLER
Reset
High-speed operation
start mode
8MHz oscillating
32kHz oscillating
φ is stopped (“H”)
Timer operating
8MHz oscillating
32kHz oscillating
φ is stopped (“H”)
Timer operating
(Note 3)
8MHz stopped
32kHz oscillating
φ is stopped (“H”)
Timer operating
(Note 3)
WIT instruction
Interrupt
External INT,
timer interrupt,
or SI/O interrupt
8MHz oscillating
32kHz oscillating
f( φ ) = 4MHz
STP instruction
Interrupt (Note 1)
CM7 = 0
External INT
8MHz stopped
32kHz stopped
φ is stopped (“H”)
CM7 = 1
WIT instruction
Interrupt
8MHz oscillating
32kHz oscillating
f( φ ) = 16kHz
STP instruction
Interrupt (Note 2)
8MHz stopped
32kHz stopped
φ is stopped (“H”)
CM6 = 1
CM6 = 0
The program must
allow time for 8MHz
oscillation to stabilize
WIT instruction
Interrupt
8MHz stopped
32kHz oscillating
f( φ ) = 16kHz
STP instruction
Interrupt (Note 2)
8MHz stopped
32kHz stopped
φ = stopped (“H”)
CPU mode register
(Address : 00FB16)
CM6 : Main clock (XIN–XOUT) stop bit
0 : Oscillating
1 : Stopped
CM7 : Internal system clock selection bit
0 : XIN-XOUT selected (high-speed mode)
1 : XCIN-XCOUT selected (low-speed mode)
The example assumes that 8 MHz is being applied to the XIN pin and 32 kHz to the XCIN pin. The φ indicates the internal clock.
Notes 1: When the STP state is ended, a delay of approximately 8ms is automatically generated by timer 3 and timer 4.
2: The delay after the STP state ends is approximately 2s.
3: When the internal clock φ divided by 8 is used as the timer count source, the frequency of the count source is 2kHz.
Fig. 94. State transitions of system clock
81