A2F500M3G-CSG288 Datasheet, PDF (26/197 Pages) Microsemi Corporation – SmartFusion Customizable System-on-Chip (cSoC)

SmartFusion DC and Switching Characteristics
Power Calculation Methodology
This section describes a simplified method to estimate power consumption of an application. For more
accurate and detailed power estimations, use the SmartPower tool in the Libero SoC software.
The power calculation methodology described below uses the following variables:
• The number of PLLs/CCCs as well as the number and the frequency of each output clock
generated
• The number of combinatorial and sequential cells used in the design
• The internal clock frequencies
• The number and the standard of I/O pins used in the design
• The number of RAM blocks used in the design
• The number of eNVM blocks used in the design
• The analog block used in the design, including the temperature monitor, current monitor, ABPS,
sigma-delta DAC, comparator, low power crystal oscillator, RC oscillator and the main crystal
oscillator
• Toggle rates of I/O pins as well as VersaTiles—guidelines are provided in Table 2-17 on
page 2-18.
• Enable rates of output buffers—guidelines are provided for typical applications in Table 2-18 on
page 2-18.
• Read rate and write rate to the memory—guidelines are provided for typical applications in
Table 2-18 on page 2-18.
• Read rate to the eNVM blocks
The calculation should be repeated for each clock domain defined in the design.
Methodology
Total Power Consumption—P_TOTAL
SoC Mode, Standby Mode, and Time Keeping Mode.
P_TOTAL = P_STAT + P_DYN
P_STAT is the total static power consumption.
P_DYN is the total dynamic power consumption.
Total Static Power Consumption—P_STAT
SoC Mode
P_STAT = P_DC1 + (N_INPUTS * P_DC7) + (N_OUTPUTS * P_DC8) + (N_PLLS * P_DC9)
N_INPUTS is the number of I/O input buffers used in the design.
N_OUTPUTS is the number of I/O output buffers used in the design.
N_PLLS is the number of PLLs available in the device.
Standby Mode
P_STAT = P_DC2
Time Keeping Mode
P_STAT = P_DC3
Total Dynamic Power Consumption—P_DYN
SoC Mode
P_DYN = P_CLOCK + P_S-CELL + P_C-CELL + P_NET + P_INPUTS + P_OUTPUTS + P_MEMORY + P_PLL + P_eNVM +
P_XTL-OSC + P_RC-OSC + P_AB + P_LPXTAL-OSC + P_MSS
2-14
Revision 12