PIC16LC74B-16 Datasheet, PDF (9/41 Pages) Microchip Technology – 8-Bit CMOS Microcontrollers with A/D Converter

PIC16LC74B-16/PTL16
2.2 DC Characteristics: PIC16LC74B-16/PTL-04 (Commercial) (Cont.’d)
DC CHARACTERISTICS
Param Sym
No.
Characteristic
Standard Operating Conditions (unless otherwise stated)
Operating temperature 0°C ≤ TA ≤ +70°C for commercial
Operating voltage VDD range as described in DC spec Section 2.1
Min Typ† Max Units
Conditions
VDD-0.7 -
-
V IOH = -2.5 mA, VDD = 4.5V,
-40°C to +125°C
D092
OSC2/CLKOUT (RC osc
VDD-0.7 -
-
V IOH = -1.3 mA, VDD = 4.5V,
mode)
-40°C to +85°C
VDD-0.7 -
-
V IOH = -1.0 mA, VDD = 4.5V,
-40°C to +125°C
D150* VOD Open-Drain High Voltage
-
-
8.5
V RA4 pin
Capacitive Loading Specs
on Output Pins
D100 COSC2 OSC2 pin
-
-
15
pF In XT, HS and LP modes when
external clock is used to drive
OSC1.
D101 CIO All I/O pins and OSC2 (in RC
-
-
50
pF
mode)
D102 Cb _{SCL, SDA in I}²_{C mode}
-
-
400 pF
* These parameters are characterized but not tested.
† Data in “Typ” column is at 3V, 25°C unless otherwise stated. These parameters are for design guidance only
and are not tested.
Note 1: In RC oscillator mode, the OSC1/CLKIN pin is a Schmitt Trigger input. It is not recommended that the
device be driven with external clock in RC mode.
2: The leakage current on the MCLR/VPP pin is strongly dependent on the applied voltage level. The specified
levels represent normal operating conditions. Higher leakage current may be measured at different input
voltages.
3: Negative current is defined as current sourced by the pin.
© 1999 Microchip Technology Inc.
Preliminary
DS30026A-page 9