English
Language : 

PIC16LC74B-16 Datasheet, PDF (12/41 Pages) Microchip Technology – 8-Bit CMOS Microcontrollers with A/D Converter
PIC16LC74B-16/PTL16
2.3.3 TIMING DIAGRAMS AND SPECIFICATIONS
FIGURE 2-3: EXTERNAL CLOCK TIMING
Q4
Q1
Q2
Q3
OSC1
CLKOUT
1
3
3
2
Q4
Q1
4
4
TABLE 2-2: EXTERNAL CLOCK TIMING REQUIREMENTS
Param Sym
No.
Characteristic
Min Typ† Max Units
(Note 2)
(Note 3)
Conditions
1A
Fosc External CLKIN Frequency
(Note 1)
DC
—
DC
—
4 MHz RC and XT osc modes
4 MHz HS osc mode (-04)
DC
—
20 MHz HS osc mode (-20)
DC
—
200 kHz LP osc mode
Oscillator Frequency
(Note 1)
DC
—
0.1
—
4 MHz RC osc mode
4 MHz XT osc mode
4
—
20 MHz HS osc mode
5
—
200 kHz LP osc mode
1
Tosc External CLKIN Period
(Note 3)
250
—
250
—
—
ns RC and XT osc modes
—
ns HS osc mode (-04)
50
—
—
ns HS osc mode (-20)
5
—
—
µs LP osc mode
Oscillator Period
(Note 3)
250
—
—
ns RC osc mode
250
— 10,000 ns XT osc mode
250
—
250 ns HS osc mode (-04)
50
—
250 ns HS osc mode (-20)
5
—
—
µs LP osc mode
2
TCY Instruction Cycle Time (Note 1) 200
—
DC
ns TCY = 4/FOSC
3*
TosL, External Clock in (OSC1) High 100
—
—
ns XT oscillator
TosH or Low Time
2.5
—
—
µs LP oscillator
15
—
—
ns HS oscillator
4*
TosR, External Clock in (OSC1) Rise —
—
25
ns XT oscillator
TosF or Fall Time
—
—
50
ns LP oscillator
—
—
15
ns HS oscillator
* These parameters are characterized but not tested.
† Data in "Typ" column is at 5V, 25°C unless otherwise stated. These parameters are for design guidance only
and are not tested.
Note 1: Instruction cycle period (TCY) equals four times the input oscillator time-base period. All specified values are
based on characterization data for that particular oscillator type under standard operating conditions with the
device executing code. Exceeding these specified limits may result in an unstable oscillator operation and/or
higher than expected current consumption.
2: All devices are tested to operate at "min." values with an external clock applied to the OSC1/CLKIN pin.
3: When an external clock input is used, the "Max." cycle time limit is "DC" (no clock) for all devices.
DS30026A-page 12
Preliminary
© 1999 Microchip Technology Inc.