PIC16F8X_13 Datasheet, PDF (89/128 Pages) Microchip Technology – 18-pin Flash/EEPROM 8-Bit Microcontrollers

PIC16CR83/84
PIC16F8X
11.1 DC CHARACTERISTICS:
PIC16CR84, PIC16CR83 (Commercial, Industrial)
DC Characteristics
Power Supply Pins
Standard Operating Conditions (unless otherwise stated)
Operating temperature 0C  TA  +70C (commercial)
-40C  TA  +85C (industrial)
Parameter Sym
No.
Characteristic
Min Typ† Max Units
Conditions
D001
D001A
VDD Supply Voltage
4.0 — 6.0 V XT, RC and LP osc configuration
4.5 ^— 5.5 V HS osc configuration
D002
VDR RAM Data Retention
Voltage⁽¹⁾
1.5* — — V Device in SLEEP mode
D003
VPOR VDD start voltage to
ensure internal
Power-on Reset signal
— VSS —
V See section on Power-on Reset for details
D004
D010
D010A
D013
D020
D021
D021A
SVDD VDD rise rate to ensure 0.05* —
internal Power-on
Reset signal
IDD Supply Current⁽²⁾
— 1.8
— _7.3
—
5
IPD Power-down Current⁽³⁾ — 7.0
— _1.0
— _1.0
— V/ms See section on Power-on Reset for details
RC and XT osc configuration⁽⁴⁾
4.5 mA
FOSC = 4.0 MHz, VDD = 5.5V
10 mA
FOSC = 4.0 MHz, VDD = 5.5V
(During EEPROM programming)
HS OSC CONFIGURATION (PIC16CR84-10)
10 mA
FOSC = 10 MHz, VDD = 5.5V
28 A VDD = 4.0V, WDT enabled, industrial
14 A VDD = 4.0V, WDT disabled, commercial
16 A VDD = 4.0V, WDT disabled, industrial
* These parameters are characterized but not tested.
† Data in "Typ" column is at 5.0V, 25°C unless otherwise stated. These parameters are for design guidance only
and are not tested.
Note 1: This is the limit to which VDD can be lowered in SLEEP mode without losing RAM data.
2: The supply current is mainly a function of the operating voltage and frequency. Other factors such as I/O pin
loading and switching rate, oscillator type, internal code execution pattern, and temperature also have an
impact on the current consumption.
The test conditions for all IDD measurements in active operation mode are:
OSC1=external square wave, from rail to rail; all I/O pins tristated, pulled to VDD, T0CKI = VDD,
MCLR = VDD; WDT enabled/disabled as specified.
3: The power down current in SLEEP mode does not depend on the oscillator type. Power-down current is
measured with the part in SLEEP mode, with all I/O pins in hi-impedance state and tied to VDD and VSS.
4: For RC osc configuration, current through Rext is not included. The current through the resistor can be esti-
mated by the formula IR = VDD/2Rext (mA) with Rext in kOhm.
 1996-2013 Microchip Technology Inc.
DS30430D-page 11-89