PIC16F630_06 Datasheet, PDF (89/130 Pages) Microchip Technology – 14-Pin, Flash-Based 8-Bit CMOS Microcontrollers

PIC16F630/676
12.2 DC Characteristics: PIC16F630/676-I (Industrial)
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for industrial
Param
No.
Device Characteristics
Min Typ† Max Units
VDD
Conditions
Note
D010
D011
D012
Supply Current (IDD)
— 9 16 μA
— 18 28 μA
— 35 54 μA
— 110 150 μA
— 190 280 μA
— 330 450 μA
— 220 280 μA
— 370 650 μA
2.0 FOSC = 32 kHz
3.0 ^{LP Oscillator Mode}
5.0
2.0 FOSC = 1 MHz
3.0 ^{XT Oscillator Mode}
5.0
2.0 FOSC = 4 MHz
3.0 ^{XT Oscillator Mode}
D013
D014
D015
— 0.6 1.4 mA
— 70 110 μA
— 140 250 μA
— 260 390 μA
— 180 250 μA
— 320 470 μA
— 580 850 μA
— 340 450 μA
— 500 780 μA
5.0
2.0 FOSC = 1 MHz
3.0 ^{EC Oscillator Mode}
5.0
2.0 FOSC = 4 MHz
3.0 ^{EC Oscillator Mode}
5.0
2.0 FOSC = 4 MHz
3.0 ^{INTOSC Mode}
D016
D017
— 0.8 1.1 mA 5.0
— 180 250 μA
— 320 450 μA
2.0 FOSC = 4 MHz
3.0 ^{EXTRC Mode}
— 580 800 μA
5.0
— 2.1 2.95 mA
— 2.4 3.0 mA
4.5 FOSC = 20 MHz
5.0 ^{HS Oscillator Mode}
† Data in ‘Typ’ column is at 5.0V, 25°C unless otherwise stated. These parameters are for design guidance
only and are not tested.
Note 1: The test conditions for all IDD measurements in Active Operation mode are: OSC1 = external square wave,
from rail to rail; all I/O pins tri-stated, pulled to VDD; MCLR = VDD; WDT disabled.
2: The supply current is mainly a function of the operating voltage and frequency. Other factors such as I/O
pin loading and switching rate, oscillator type, internal code execution pattern, and temperature also have
an impact on the current consumption.
© 2006 Microchip Technology Inc.
DS40039D-page 87