PIC18F14K22LIN Datasheet, PDF (42/62 Pages) Microchip Technology – 20-Pin Flash Microcontrollers 20-Pin Flash Microcontrollers

PIC18F14K22LIN
8.3 DC Characteristics: Primary Run Supply Current, PIC18F14K22LIN
PIC18F14K22LIN
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C  TA  +125°C for extended
Param
No.
Device Characteristics
Typ. Max. Units
Conditions
D014
FOSC = 1 MHz
(PRI_RUN,
.30 .42 mA -40°C to +125°C VDD = 5.0V _{EC Med Osc)}
D015
FOSC = 16 MHz
(PRI_RUN,
3.9 4.4 mA -40°C to +125°C VDD = 5.0V _{EC High Osc)}
D016
12.1 14.6 mA -40°C to +125°C
VDD = 5.0V
FOSC = 64 MHz
(PRI_RUN,
EC High Osc)
D017
FOSC = 4 MHz
16 MHz Internal
3.8 4.8 mA -40°C to +125°C VDD = 5.0V _{(PRI_RUN HS+PLL)}
D018
12.6 15.6 mA -40°C to +125°C
VDD = 5.0V
FOSC = 16 MHz
64 MHz Internal
(PRI_RUN HS+PLL)
* These parameters are characterized but not tested.
Note 1: The test conditions for all IDD measurements in active operation mode are: OSC1 = external square wave, from
rail-to-rail; all I/O pins tri-stated, pulled to VDD; MCLR = VDD; WDT disabled.
2: The supply current is mainly a function of the operating voltage and frequency. Other factors, such as I/O pin
loading and switching rate, oscillator type, internal code execution pattern and temperature, also have an impact
on the current consumption.
3: For RC oscillator configurations, current through REXT is not included. The current through the resistor can be
extended by the formula IR = VDD/2REXT (mA) with REXT in k
4: FVR and BOR are disabled.
5: When a single temperature range is provided for a parameter, the specification applies to both industrial and extended
temperature devices.
DS41580A-page 46
Preliminary
 2011 Microchip Technology Inc.