|
PIC16F87XA Datasheet, PDF (30/234 Pages) Microchip Technology – 28/40/44-Pin Enhanced Flash Microcontrollers | |||
|
◁ |
PIC16F87XA
2.2.2.7 PIR2 Register
The PIR2 register contains the flag bits for the CCP2
interrupt, the SSP bus collision interrupt, EEPROM
write operation interrupt and the comparator interrupt.
Note:
Interrupt flag bits are set when an interrupt
condition occurs regardless of the state of
its corresponding enable bit or the global
enable bit, GIE (INTCON<7>). User
software should ensure the appropriate
interrupt flag bits are clear prior to
enabling an interrupt.
REGISTER 2-7:
PIR2 REGISTER (ADDRESS 0Dh)
U-0
R/W-0
U-0
R/W-0
â
CMIF
â
EEIF
bit 7
R/W-0
BCLIF
U-0
U-0
R/W-0
â
â
CCP2IF
bit 0
bit 7
bit 6
bit 5
bit 4
bit 3
bit 2-1
bit 0
Unimplemented: Read as â0â
CMIF: Comparator Interrupt Flag bit
1 = The comparator input has changed (must be cleared in software)
0 = The comparator input has not changed
Unimplemented: Read as â0â
EEIF: EEPROM Write Operation Interrupt Flag bit
1 = The write operation completed (must be cleared in software)
0 = The write operation is not complete or has not been started
BCLIF: Bus Collision Interrupt Flag bit
1 = A bus collision has occurred in the SSP when configured for I2C Master mode
0 = No bus collision has occurred
Unimplemented: Read as â0â
CCP2IF: CCP2 Interrupt Flag bit
Capture mode:
1 = A TMR1 register capture occurred (must be cleared in software)
0 = No TMR1 register capture occurred
Compare mode:
1 = A TMR1 register compare match occurred (must be cleared in software)
0 = No TMR1 register compare match occurred
PWM mode:
Unused.
Legend:
R = Readable bit
- n = Value at POR
W = Writable bit
â1â = Bit is set
U = Unimplemented bit, read as â0â
â0â = Bit is cleared x = Bit is unknown
DS39582B-page 28
 2003 Microchip Technology Inc.
|
▷ |