|
PIC16F720_13 Datasheet, PDF (203/254 Pages) Microchip Technology – 20-Pin Flash Microcontrollers | |||
|
◁ |
PIC16(L)F720/721
TABLE 23-8: PIC16F720/721 A/D CONVERSION REQUIREMENTS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ï£ TA ï£ +125°C
Param.
No.
Sym.
Characteristic
AD130* TAD A/D Clock Period
AD131 TCNV
AD132* TACQ
A/D Internal RC Oscillator
Period
Conversion Time (not including
Acquisition Time)(1)
Acquisition Time
Min.
1.0
4.0
1.0
â
Typâ
â
â
2.0
10.5
2
Max. Units
Conditions
9.0
16.0
6.0
â
â
ïS VDD ï¾ 2.0V(2)
ïS VDD ï£ 2.0V(2)
(ADRC mode)
ïS
TAD Set GO/DONE bit to new data in A/D
Result register
ïS VDD = 3.0V, EC or INTOSC Clock
mode(3)
* These parameters are characterized but not tested.
â Data in âTypâ column is at 5.0V, 25°C unless otherwise stated. These parameters are for design guidance only and are
not tested.
Note 1: The ADRES register may be read on the following TCY cycle.
2: Setting of 16.0 ïs TAD not recommended for temperature > 85°C.
3: If ADRC mode is selected for use with VDD ï£ï 2.0V, longer acquisition times will be required (see Section 9.3 âA/D
Acquisition Requirementsâ)
FIGURE 23-11: PIC16F720/721 A/D CONVERSION TIMING (NORMAL MODE)
BSF ADCON0, GO
AD134
Q4
A/D CLK
A/D Data
(TOSC/2(1))
AD131
AD130
1 TCY
7
6
5
4
3
2
1
0
ADRES
ADIF
GO
Sample AD132
OLD_DATA
Sampling Stopped
NEW_DATA
1 TCY
DONE
Note 1: If the A/D clock source is selected as RC, a time of TCY is added before the A/D clock starts. This allows the
SLEEP instruction to be executed.
ï£ 2010-2013 Microchip Technology Inc.
DS41430D-page 203
|
▷ |