English
Language : 

MAX12553 Datasheet, PDF (6/28 Pages) Maxim Integrated Products – 14-Bit, 65Msps, 3.3V ADC
14-Bit, 65Msps, 3.3V ADC
ELECTRICAL CHARACTERISTICS (continued)
(VDD = 3.3V, OVDD = 2.0V, GND = 0, REFIN = REFOUT (internal reference), VIN = -0.5dBFS, CLKTYP = high, DCE = high, PD = low,
G/T = low, fCLK = 65MHz (50% duty cycle), TA = -40°C to +85°C, unless otherwise noted. Typical values are at TA = +25°C.) (Note 1)
PARAMETER
SYMBOL
CONDITIONS
MIN
Normal operating mode,
fIN = 175MHz at -0.5dBFS, CLKTYP = GND,
single-ended clock
Analog Power Dissipation
PDISS
Normal operating mode,
fIN = 175MHz at -0.5dBFS,
CLKTYP = OVDD, differential clock
Power-down mode clock idle, PD = OVDD
Digital Output Supply Current
IOVDD
Normal operating mode,
fIN = 175MHz at -0.5dBFS, OVDD = 2.0V,
CL ≈ 5pF
Power-down mode clock idle, PD = OVDD
TIMING CHARACTERISTICS (Figure 6)
Clock Pulse-Width High
tCH
Clock Pulse-Width Low
tCL
Data-Valid Delay
tDAV CL = 5pF (Note 6)
Data Setup Time Before Rising
Edge of DAV
tSETUP CL = 5pF (Notes 5, 6)
8.5
TYP MAX UNITS
337
mW
363
406
0.15
8.2
mA
20
µA
7.7
ns
7.7
ns
6.9
ns
ns
Data Hold Time After Rising Edge
of DAV
Wake-Up Time from Power-Down
tHOLD
tWAKE
CL = 5pF (Notes 5, 6)
VREFIN = 2.048V
6.3
ns
10
ms
Note 1: Specifications ≥+25°C guaranteed by production test; <+25°C guaranteed by design and characterization.
Note 2: See definitions in the Parameter Definitions section at the end of this data sheet.
Note 3: Specifications guaranteed by design and characterization. Devices tested for performance during production test.
Note 4: During power-down, D13–D0, DOR, and DAV are high impedance.
Note 5: Guaranteed by design and characterization.
Note 6: Digital outputs settle to VIH or VIL.
Note 7: Due to test-equipment-jitter limitations at 175MHz, 0.15% of the spectrum on each side of the fundamental is excluded from
the spectral analysis.
Note 8: Limit specifications include performance degradations due to a production test socket. Performance is improved when the
MAX12553 is soldered directly to the PC board.
6 _______________________________________________________________________________________