MAX12553 Datasheet, PDF (17/28 Pages) Maxim Integrated Products – 14-Bit, 65Msps, 3.3V ADC

14-Bit, 65Msps, 3.3V ADC
(V_REFP - V_REFN) x 2/3
(V_REFN - V_REFP) x 2/3
CLKN
CLKP
DAV
D13–D0
DOR
DIFFERENTIAL ANALOG INPUT (INP–INN)
N+4 N+5
N+3
N-3 _{N-2 N-1 N N+1 N+2}
N+6
N+7
N+9
N+8
t_AD
t_DAV
t_CL
t_CH
t_SETUP
t_HOLD
N-3 N-2 N-1 N N+1 N+2 N+3 N+4 N+5 N+6 N+7 N+8 N+9
8.5 CLOCK-CYCLE DATA LATENCY
t_SETUP
t_HOLD
Figure 6. System-Timing Diagram
System-Timing Requirements
Figure 6 shows the relationship between the clock, ana-
log inputs, DAV indicator, DOR indicator, and the result-
ing output data. The analog input is sampled on the
falling edge of the clock signal and the resulting data
appears at the digital outputs 8.5 clock cycles later.
The DAV indicator is synchronized with the digital out-
put and optimized for use in latching data into digital
back-end circuitry. Alternatively, digital back-end cir-
cuitry can be latched with the falling edge of the con-
version clock (CLKP-CLKN).
Data-Valid Output (DAV)
DAV is a single-ended version of the input clock (CLKP).
Output data changes on the falling edge of DAV, and
DAV rises once output data is valid (Figure 6).
The state of the duty-cycle equalizer input (DCE)
changes the waveform at DAV. With the duty-cycle
equalizer disabled (DCE = low), the DAV signal is the
inverse of the signal at CLKP delayed by 6.8ns (t_DAV).
With the duty-cycle equalizer enabled (DCE = high), the
DAV signal has a fixed pulse width that is independent of
CLKP. In either case, with DCE high or low, output data
at D13–D0 and DOR are valid from 8.5ns before the ris-
ing edge of DAV to 6.3ns after the rising edge of DAV,
and the rising edge of DAV is synchronized to have a
6.9ns (t_DAV) delay from the falling edge of CLKP.
DAV is high impedance when the MAX12553 is in
power-down (PD = high). DAV is capable of sinking
and sourcing 600µA and has three times the drive
strength of D13–D0 and DOR. DAV is typically used to
latch the MAX12553 output data into an external back-
end digital circuit.
Keep the capacitive load on DAV as low as possible
(<25pF) to avoid large digital currents feeding back
into the analog portion of the MAX12553 and degrading
its dynamic performance. An external buffer on DAV
isolates it from heavy capacitive loads. Refer to the
MAX12555 evaluation kit schematic for an example of
DAV driving back-end digital circuitry through an exter-
nal buffer.
______________________________________________________________________________________ 17