GAL22V10 Datasheet, PDF (6/29 Pages) Lattice Semiconductor – High Performance E2CMOS PLD Generic Array Logic

SpSepceifcicifaictaiotinosnsGGALA2L22V21V01D0
Absolute Maximum Ratings¹
Recommended Operating Conditions
Supply voltage V_CC ....................................... -0.5 to +7V
Input voltage applied ........................... -2.5 to V_CC +1.0V
Off-state output voltage applied........... -2.5 to V_CC +1.0V
Storage Temperature.................................. -65 to 150°C
Ambient Temperature with
Power Applied ......................................... -55 to 125°C
1. Stresses above those listed under the “Absolute Maximum
Ratings” may cause permanent damage to the device. These
are stress only ratings and functional operation of the device
at these or at any other conditions above those indicated in
the operational sections of this specification is not implied
(while programming, follow the programming specifications).
Commercial Devices:
Ambient Temperature (T_A) ............................. 0 to +75°C
Supply voltage (V_CC)
with Respect to Ground ..................... +4.75 to +5.25V
Industrial Devices:
Ambient Temperature (T_A) ............................ -40 to 85°C
Supply voltage (V_CC)
with Respect to Ground ..................... +4.50 to +5.50V
DC Electrical Characteristics
Over Recommended Operating Conditions (Unless Otherwise Specified)
SYMBOL
PARAMETER
CONDITION
MIN. TYP.³ MAX. UNITS
VIL
Input Low Voltage
Vss – 0.5 —
VIH
Input High Voltage
2.0
—
IIL¹
Input or I/O Low Leakage Current 0V ≤ VIN ≤ VIL (MAX.)
—
—
IIH
Input or I/O High Leakage Current 3.5V ≤ VIN ≤ VCC
—
—
VOL
Output Low Voltage
IOL = MAX. Vin = VIL or VIH
—
—
VOH
Output High Voltage
IOH = MAX. Vin = VIL or VIH
2.4
—
IOL
Low Level Output Current
—
—
IOH
High Level Output Current
—
—
IOS²
Output Short Circuit Current
COMMERCIAL
VCC = 5V VOUT = 0.5V T_A = 25°C
–30
—
ICC
Operating Power
VIL = 0.5V VIH = 3.0V
L-4/-5/-7
—
90
Supply Current
ftoggle = 15MHz Outputs Open L-10
—
90
L-15/-25
—
75
Q-10/-15/-25 —
45
INDUSTRIAL
ICC
Operating Power
Supply Current
VIL = 0.5V VIH = 3.0V
L-7/-10
—
90
ftoggle = 15MHz Outputs Open L-15/-20/-25 —
75
0.8
V
Vcc+1 V
–100 µA
10
µA
0.4
V
—
V
16
mA
–3.2 mA
–130 mA
140 mA
130 mA
90
mA
55
mA
160 mA
130 mA
1) The leakage current is due to the internal pull-up on all pins. See Input Buffer section for more information.
2) One output at a time for a maximum duration of one second. Vout = 0.5V was selected to avoid test problems caused by tester
ground degradation. Characterized but not 100% tested.
3) Typical values are at Vcc = 5V and TA = 25 °C
6