ICE40HX1K-VQ100 Datasheet, PDF (3/12 Pages) Lattice Semiconductor – iCE40™ HX-Series Ultra Low-Power FPGA Family

iCE40 HX-Series Ultra-Low Power Family
Electrical Characteristics
All parameter limits are specified under worst-case supply voltage, junction temperature, and processing conditions.
Absolute Maximum Ratings
Stresses beyond those listed under Table 2 may cause permanent damage to the device. These are stress ratings only;
functional operation of the device at these or any other conditions beyond those listed under the Recommended
Operating Conditions is not implied. Exposure to absolute maximum conditions for extended periods of time
adversely affects device reliability.
Symbol
VCC
VPP_2V5
VPP_FAST
VCCIO_0
VCCIO_1
VCCIO_2
VCCIO_3
SPI_VCC
VIN_0
VIN_1
VIN_2
VIN_SPI
VIN_3
VCCPLL
I_OUT
T_J
T_STG
Table 2: Absolute Maximum Ratings
Description
Minimum
Core supply Voltage
–0.5
VPP_2V5 NVCM programming and operating supply
Optional fast NVCM programming supply
I/O bank supply voltage (I/O Banks 0, 1, 2 and 3 plus SPI
–0.5
interface)
Maximum
1.42
4.00
Voltage applied to PIO pin within a specific I/O bank (I/O
Banks 0, 1, 2 and 3 plus SPI interface)
–1.0
3.6
Analog voltage supply to the Phase Locked Loop (PLL)
DC output current per pin
Junction temperature
Storage temperature, no bias
–0.5
1.30
—
20
–55
125
–65
150
Units
V
V
V
V
V
V
mA
°C
°C
Recommended Operating Conditions
Table 3: Recommended Operating Conditions
Symbol
Description
Minimum Nominal Maximum Units
VCC
VPP_2V5¹
VPP_FAST²
SPI_VCC
VCCIO_0
VCCIO_1
VCCIO_2
VCCIO_3
SPI_VCC
VCCPLL³
T_A
T_PROG
Notes:
Core supply voltage
High Performance, low-power
VPP_2V5 NVCM
Release from Power-on Reset
programming and operating Configure from NVCM
supply
NVCM programming
Optional fast NVCM programming supply
SPI interface supply voltage
I/O standards, all banks
LVCMOS33
LVCMOS25, LVDS
LVCMOS18, SubLVDS
LVCMOS15
Analog voltage supply to the Phase Locked Loop (PLL)
Ambient temperature
NVCM programming temperature
1.14
1.20
1.26
V
1.30
—
3.47
V
2.30
—
3.47
V
2.30
—
3.00
V
Leave unconnected in application
1.71
—
3.47
V
2.70
3.30
3.47
V
2.38
2.50
2.63
V
1.71
1.80
1.89
V
1.43
1.50
1.58
V
1.14
1.20
–40
—
10
25
1.26
V
85
°C
30
°C
1. VPP_2V5 must be connected to a valid voltage, when the iCE40HX device is active.
2. VPP_FAST, used only for fast production programming, must be left floating or unconnected in application.
3. VCCPLL must be tied to VCC when PLL is not used.
Lattice Semiconductor Corporation
www.latticesemi.com/
(1.32, 03-OCT-2012)
3