E5263A Datasheet, PDF (11/15 Pages) Keysight Technologies – 2 Channel IV Analyzer/Source Monitor Unit

11 | Keysight | E5262A 2 Channel IV Analyzer Source Monitor Unit, E5263A 2 Channel IV Analyzer Source Monitor Unit – Data Sheet
Measurement modes and functions
Operation Mode
Application test mode
The application test mode provides application oriented point-
and-click test setup and execution. An application test can be se-
lected from the library by device type and desired measurement,
and then executed after modifying the default input parameters
as needed. Available application tests can be adapted to config-
ured resources.
Classic test mode
The classic test mode provides easy access to the instrument
setup and measurement execution capabilities.
Tracer test mode
The tracer test mode offers intuitive and interactive sweep control
using a rotary knob similar to a curve tracer. Just like an analog
curve tracer, you can sweep in only one direction (useful for R&D
device analysis) or in both directions (useful in failure analysis
applications). Test set ups created in tracer test mode can be
seamlessly and instantaneously transferred to classic test mode
for further detailed measurement and analysis.
Quick test mode
A GUI-based Quick Test mode enables you to perform test se-
quencing without programming. You can select, copy, rearrange
and cut-and-paste any application tests with a few simple mouse
clicks. Once you have selected and arranged your tests, simply
click on the measurement button to begin running an automated
test sequence.
Current offset cancel
This function subtracts the offset current from the current
measurement raw data, and returns the result as the measure-
ment data. This function is used to compensate the error factor
(offset current) caused by the measurement path such as the
measurement cables, manipulators, or probe card.
Data display, analysis and
arithmetic functions
Data Display
X-Y graph plot
X-axis and up to eight Y-axes, linear and log scale, real time
graph plotting.
Scale: Auto scale and zoom
Marker: Marker to min/max, interpolation, direct marker, and
marker skip
Cursor: Direct cursor
Line: Two lines, normal mode, grad mode, tangent mode, and
regression mode
Overlay graph comparison: Graphical plots can be overlaid.
List display
Measurement data and calculated user function data are listed
in conjunction with sweep step number or time domain sampling
step number. Up to 20 data sets can be displayed.
Data variable display
Up to 20 user-defined parameters can be displayed on the
graphics screen.
Other measurement characteristics
Measurement control
Single, repeat, append, and stop
SMU setting capabilities
Limited auto ranging, voltage/current compliance, power
compliance, automatic sweep abort functions, self-test, and
self-calibration
Standby mode
SMUs in “Standby” remain programmed to their specified output
value even as other units are reset for the next measurement.
Bias hold function
This function allows you to keep a source active between
measurements. The source module will apply the specified
bias between measurements when running classic tests inside
an application test, in quick test mode, or during a repeated
measurement. The function ceases as soon as these conditions
end or when a measurement that does not use this function
is started.
Automatic analysis function
On a graphics plot, the markers and lines can be automatically
located using the auto analysis setup. Parameters can be auto-
matically determined using automatic analysis, user function,
and read out functions.
Analysis functions
Up to 20 user-defined analysis functions can be defined using
arithmetic expressions.
Measured data, pre-defined variables, and read out functions
can be used in the computation, and the result can be displayed.
Read out functions
The read out functions are built-in functions for reading various
values related to the marker, cursor, or line.
Data export
X-Y graph plot can be printed or stored as image data to
clipboard or mass storage device. (File type: bmp, gif, png,
emf). Graph and list data can be exported to Excel.