ICL8052 Datasheet, PDF (5/21 Pages) Intersil Corporation – 14-Bit/16-Bit, Microprocessor- Compatible, 2-Chip, A/D Converter

ICL8052/ICL7104, ICL8068/ICL7104
Absolute Maximum Ratings
ICL8052, ICL8068
Supply Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ±18V
Differential Input Voltage
(8068) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ±30V
(8052) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ±6V
Input Voltage (Note 2). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ±15V
Output Short Circuit Duration All Outputs (Note 3). . . . . . . Indefinite
ICL7104
V+ Supply (GND to V+) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12V
V++ to V-. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32V
Positive Supply Voltage (GND to V++) . . . . . . . . . . . . . . . . . . . . 17V
Negative Supply Voltage (GND to V-). . . . . . . . . . . . . . . . . . . . .-17V
Analog Input Voltage (Pins 32 - 39)(Note 4). . . . . . . . . . . . V++ to V-
Digital Input Voltage
(Pins 2 - 30) (Note 5) . . . . . . . . . . . . (GND - 0.3V) to (V+ + 0.3V)
Thermal Information
Thermal Resistance (Typical, Note 1)
θ_JA (^oC/W) θ_JC (^oC/W)
14 Ld PDIP Package . . . . . . . . . . . . . . 100
N/A
40 Ld PDIP Package . . . . . . . . . . . . . .
60
N/A
14 Ld CERDIP Package . . . . . . . . . . .
75
20
Maximum Junction Temperature (Ceramic Package) . . . . . . . . . 175^oC
Maximum Junction Temperature (Plastic Package) . . . . . . . . 150^oC
Maximum Storage Temperature Range . . . . . . . . . .-65^oC to 150^oC
Maximum Lead Temperature (Soldering, 10s) . . . . . . . . . . . . 300^oC
Operating Conditions
Temperature Range . . . . . . . . . . . . . . . . . . . . . . . . . . . .0^oC to 70^oC
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation
of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
NOTES:
1. θ_JA is measured with the component mounted on an evaluation PC board in free air.
2. For supply voltages less than ±15V, the absolute maximum input voltage is equal to the supply voltage.
3. Short circuit may be to ground or either supply. Rating applies to 70^oC ambient temperature.
4. Input voltages may exceed the supply voltages provided the input current is limited to ±100µA.
5. Connecting any digital inputs or outputs to voltages greater than V+ or less than GND may cause destructive device latchup. For this
reason it is recommended that the power supply to the ICL7104 be established before any inputs from sources not on that supply are
applied.
ICL7104 Electrical Specifications V+ = +5V, V++ = +15V, V- = -15V, T_A = 25^oC, f_CLOCK = 200kHz
PARAMETER
SYMBOL
TEST
CONDITIONS
MIN
TYP
Clock Input, CLK 1
Comparator I/P, COMP IN (Note 6)
Inputs with Pulldown, MODE
Inputs with Pullups
SEN, R/H
LBEN, MBEN, HBEN, CE/LD (Note 7)
I_IN
V_IN = +5V to 0V
I_IN
V_IN = 0V to +5V
I_IH
V_IN = +5V
I_IL
V_IN = 0V
I_IH
V_IN = +5V
I_IL
V_IN = 0V
±2
±7
-10 ±0.001
1
5
-10
±0.01
-10
±0.01
-30
-5
Input High Voltage, All Digital Inputs
Input Low Voltage, All Digital Inputs
Digital Outputs Three-Stated On,
LBEN, MBEN (16 Only), HBEN, CE/LD
BIT n, POL, OR (Note 8)
Digital Outputs Three-Stated Off
Bit n, POL, OR
V_IH
V_IL
V_OL
V_OH
V_OH
I_OL
I_OL = 1.6mA
I_OH = -10µA
I_OH = -240µA
0 ≤ V_OUT ≤ V+
2.5
2.0
-
1.5
-
0.27
-
4.5
2.4
3.5
-10 ±0.001
Non Three-State Digital Output
STTS
Clock 2
Clock 3 (-14 Only)
V_OL
V_OH
V_OL
V_OH
V_OL
V_OH
I_OL = 3.2mA
I_OH = -400µA
I_OL= 320µA
I_OH = -320µA
I_OL = 1.6mA
I_OH = -320µA
-
0.3
2.4
3.3
-
0.5
-
4.5
-
0.27
2.4
3.5
MAX
±30
10
30
10
10
-1
-
1.0
0.4
-
-
+10
0.4
-
-
-
0.4
-
UNITS
µA
µA
µA
µA
µA
µA
V
V
V
V
V
µA
V
V
V
V
V
V
5-10