83C196EA Datasheet, PDF (21/40 Pages) Intel Corporation – CHMOS 16-BIT MICROCONTROLLER

83C196EA CHMOS 16-BIT MICROCONTROLLER — AUTOMOTIVE
6.0 ELECTRICAL CHARACTERISTICS
ABSOLUTE MAXIMUM RATINGS^†
Storage Temperature .................................. –60°C to +150°C
Supply Voltage with Respect to V_SS ............... –0.5 V to +7.0 V
Power Dissipation .......................................................... 1.5 W
OPERATING CONDITIONS^†
NOTICE: This document contains information on
products in the design phase of development. The
specifications are subject to change without notice.
Verify with your local Intel sales office that you
have the latest datasheet before finalizing a
design.
T_C (Case Temperature Under Bias) .............. –40°C to +125°C
V_CC (Digital Supply Voltage) .............................. 4.5 V to 5.5 V
V_REF (Analog Supply Voltage) ........................... 4.5 V to 5.5 V
F_XTAL1 (Input frequency for V_CC = 4.5 V – 5.5 V)
(Note 1) ................................................ 20 MHz to 40 MHz
†_{WARNING: Stressing the device beyond the}
“Absolute Maximum Ratings” may cause perma-
nent damage. These are stress ratings only. Oper-
ation beyond the “Operating Conditions” is not
recommended and extended exposure beyond the
NOTE:
1. This device is static and should operate below
“Operating Conditions” may affect device
reliability.
1 Hz, but has been tested only down to 20 MHz.
6.1 DC Characteristics
Symbol
Table 6. DC Characteristics at V_CC = 4.5 V – 5.5 V
Parameter
Min
Typical
(Note 1)
Max
Units
Test
Conditions
I_CC
V_CC supply current
120
135
mA XTAL1 = 40 MHz
V_CC = 5.5 V
Device in Reset
I_IDLE
Idle mode current
I_PD
Powerdown mode current
I_REF
A/D reference supply current
60
95
mA XTAL1 = 40 MHz
V_CC = 5.5 V
20
50
µA V_CC = 5.5 V
TBD
mA XTAL1 = 40 MHz
V_CC = V_REF = 5.5 V
Device in Reset
I_INJD
Maximum injection current per
–10
port on bidirectional pins
(Note 4)
10
mA
I_LI
Input leakage current
–10
(Standard inputs except
analog inputs)
10
µA V_SS < V_IN < V_CC
NOTES:
1. Typical values are based on a limited number of samples and are not guaranteed. The values listed
are at room temperature with V_CC = 5.0 V.
2. For P2.7:0, P3.7:0, P4.7:0, P5.7:0, P6.7:0, P10.3:0, P11.7:0, P12.4:0, AD15:0, EA#, RESET#,
PLLEN, NMI, TDI, TCLK, ONCE#, and XTAL1.
3. For P7.7:0, P8.7:0, P9.7:0, and P10.5:4.
4. The maximum injection current is not tested. The device is designed to meet this specification.
5. Pin capacitance is not tested. This value is based on design simulations.
ADVANCE INFORMATION
17