XC228X Datasheet, PDF (74/110 Pages) Infineon Technologies AG – 16/32-Bit Single-Chip Microcontroller with 32-Bit Performance

XC2287 / XC2286 / XC2285
XC2000 Family Derivatives
Preliminary
Electrical Parameters
4
Electrical Parameters
The operating range for the XC228x is defined by its electrical parameters. For proper
operation the indicated limitations must be respected when designing a system.
Attention: The parameters and values listed in the following sections of this
Preliminary Data Sheet are preliminary and will be adjusted and
amended after the complete device characterization has been
completed.
4.1
General Parameters
These parameters are valid for all subsequent descriptions, unless otherwise noted.
Table 9
Absolute Maximum Rating Parameters
Parameter
Symbol Values
Min. Typ. Max.
Storage temperature
T_ST
-65 –
Junction temperature
T_J
-40 –
Voltage on V_DDI pins with V_DDIM, -0.5 –
respect to ground (V_SS) V_DDI1
Voltage on V_DDP pins with V_DDPA, -0.5 –
respect to ground (V_SS) V_DDPB
Voltage on any pin with V_IN
respect to ground (V_SS)
-0.5 –
Input current on any pin –
-10 –
during overload condition
150
150
1.65
6.0
V_DDP
+ 0.5
10
Absolute sum of all input –
currents during overload
condition
–
–
|100|
Unit Note /
Test Condition
°C –
°C under bias
V–
V–
V
V_IN < V_DDPmax
mA –
mA –
Note: Stresses above those listed under “Absolute Maximum Ratings” may cause
permanent damage to the device. This is a stress rating only and functional
operation of the device at these or any other conditions above those indicated in
the operational sections of this specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may affect device reliability.
During absolute maximum rating overload conditions (V_IN > V_DDP or V_IN < V_SS) the
voltage on V_DDP pins with respect to ground (V_SS) must not exceed the values
defined by the absolute maximum ratings.
Data Sheet
72
V0.91, 2007-02
Draft Version