XC228X Datasheet, PDF (101/110 Pages) Infineon Technologies AG – 16/32-Bit Single-Chip Microcontroller with 32-Bit Performance

XC2287 / XC2286 / XC2285
XC2000 Family Derivatives
Preliminary
Electrical Parameters
Bus Cycle Control via READY Input
The duration of an external bus cycle can be controlled by the external circuitry via the
READY input signal. The polarity of this input signal can be selected.
Synchronous READY permits the shortest possible bus cycle but requires the input
signal to be synchronous to the reference signal CLKOUT.
Asynchronous READY puts no timing constraints on the input signal but incurs one
waitstate minimum due to the additional synchronization stage. The minimum duration
of an asynchronous READY signal to be safely synchronized must be one CLKOUT
period plus the input setup time.
An active READY signal can be deactivated in response to the trailing (rising) edge of
the corresponding command (RD or WR).
If the next following bus cycle is READY-controlled, an active READY signal must be
disabled before the first valid sample point for the next bus cycle. This sample point
depends on the programmed phases of the next following cycle.
Data Sheet
99
V0.91, 2007-02
Draft Version