XC2734X_13 Datasheet, PDF (57/106 Pages) Infineon Technologies AG – 16/32-Bit Single-Chip Microcontroller with 32-Bit Performance

XC2734X
XC2000 Family / Value Line
Electrical Parameters
4
Electrical Parameters
The operating range for the XC2734X is defined by its electrical parameters. For proper
operation the specified limits must be respected when integrating the device in its target
environment.
4.1
General Parameters
These parameters are valid for all subsequent descriptions, unless otherwise noted.
Table 11 Absolute Maximum Rating Parameters
Parameter
Symbol
Values
Unit Note /
Min. Typ. Max.
Test Condition
Output current on a pin I_OH SR -30 −
−
mA
when high value is driven
Output current on a pin I_OL SR −
−
when low value is driven
Overload current
I_OV SR -10
−
Absolute sum of overload Σ|I_OV| −
−
currents
SR
30
mA
10
mA
1)
100 mA
1)
Junction Temperature
T_J SR -40 −
Storage Temperature
T_ST SR -65
−
Digital supply voltage for V_DDP SR -0.5 −
IO pads and voltage
regulators
150 °C
150 °C
6.0 V
Voltage on any pin with V_IN SR -0.5 −
respect to ground (Vss)
V_DDP + V
0.5
V_IN≤ V_DDP(max)
1) Overload condition occurs if the input voltage V_IN is out of the absolute maximum rating range. In this case the
current must be limited to the listed values by design measures.
Note: Stresses above the values listed under “Absolute Maximum Ratings” may cause
permanent damage to the device. This is a stress rating only. Functional operation
of the device at these or any other conditions above those indicated in the
operational sections of this specification is not implied. Exposure to absolute
maximum rating conditions for an extended time may affect device reliability.
During absolute maximum rating overload conditions (V_IN > V_DDP or V_IN < V_SS) the
voltage on V_DDP pins with respect to ground (V_SS) must not exceed the values
defined by the absolute maximum ratings.
Data Sheet
57
V1.5, 2013-02