GMS81C1102 Datasheet, PDF (53/89 Pages) Hynix Semiconductor – 8-BIT SINGLE-CHIP MICROCONTROLLERS

GMS81C1102 / GMS81C1202
16.5 16-bit Capture Mode
16-bit capture mode is the same as 8-bit capture, except
that the Timer register is being run will 16 bits.
The clock source of the Timer 0 is selected either internal
or external clock by bit T0CK2, T0CK1 and T0CK0.
In 16-bit mode, the bits T1CK1,T1CK0 and 16BIT of TM1
should be set to "1" respectively.
TM0
TM1
EC0
fxin
INT0
ADDRESS : D0H
-
-
CAP0 T0CK2 T0CK1 T0CK0 T0CN T0ST
RESET VALUE : --000000
-
-
1
X
X
X
X
X
POL
16BIT PWME CAP1 T1CK1 T1CK0 T1CN T1ST
ADDRESS : D2H
RESET VALUE : 00000000
X
1
0
X
1
1
X
X
X : The value "0" or "1" corresponding your operation.
T0CK[2:0]
Edge Detector
T0ST
0 : Stop
1 : Start
÷2
÷4
÷8
÷ 32
÷ 128
÷ 512
÷ 2048
MUX
1
T0CN
CAPTURE
T0 + T1 ( 16-bit )
CLEAR
COMPARATOR
CDR1 CDR0 TDR1 TDR0
( 8-bit ) ( 8-bit ) ( 8-bit ) ( 8-bit )
T0IF
INT0IF
TIMER 0
INTERRUPT
INT 0
INTERRUPT
IEDS[1:0]
Figure 16-9 16-bit Capture Mode
16.6 PWM Mode
The GMS81C1202 has a two high speed PWM (Pulse
Width Modulation) functions which shared with Timer1.
In PWM mode, pin RB4/COMP0/PWM0 outputs up to a
10-bit resolution PWM output. This pin should be defined
as a PWM output by setting "1" bit PWMO in RBFUNC
register.
The period of the PWM output is determined by the
T1PPR (PWM0 Period Register) and PWM0HR[3:2]
(bit3,2 of PWM0 High Register) and the duty of the PWM
output is determined by the T1PDR (PWM0 Duty Regis-
ter) and PWM0HR[1:0] (bit1,0 of PWM0 High Register).
The user writes the lower 8-bit period value to the T1PPR
and the higher 2-bit period value to the PWM0HR[3:2].
And writes duty value to the T1PDR and the
PWM0HR[1:0] same way.
The T1PDR is configured as a double buffering for glitch-
less PWM output. In Figure 16-10 , the duty data is trans-
fered from the master to the slave when the period data
matched to the counted value. ( i.e. at the beginning of next
duty cycle )
PWM Period = [ PWM0HR[3:2]T1PPR ] X Source Clock
PWM Duty = [ PWM0HR[1:0]T1PDR ] X Source Clock
The relation of frequency and resolution is in inverse pro-
portion. Table 16-2 shows the relation of PWM frequency
vs. resolution.
50
Jan. 2002 ver 2.0