HCPL-810J Datasheet, PDF (7/16 Pages) Agilent(Hewlett-Packard) – PLC Powerline DAA IC

Electrical Specifications
Unless otherwise noted, for sinusoidal waveform input and reference resistor R_ref = 24 kΩ, all typical values are at T_A = 25°C,
V_CC1 = 5 V, V_CC2 = 5 V; all Minimum/Maximum specifications are at Recommended Operating Conditions.
General
Parameter
Symbol Min. Typ.
V_CC1 Supply Current
I_CC1
6
20
V_CC2 Supply Current
I_CC2
22
40
Status Logic High Output
Status Logic Low Output
V_CC2 Under Voltage Detection
Junction Over-Temperature
Threshold
V_OH
V_OL
V_UVD
T_th
V_CC1−1
3.8
4
130
Load Detection Threshold
0.6
Isolation Mode Rejection
IMRR
80
Ratio
Max. Unit
20 mA
35 mA
30 mA
70 mA
V
1
V
4.3 V
°C
A_PP
dB
Test Condition
V_Tx-en = 0 V
V_Tx-en = 5 V
V_Tx-en = 0 V
V_Tx-en = 5 V
I_OH = −4 mA
V_CC2 = 3.5 V, I_OL = 4 mA
V_Tx-en = 5 V, f = 132 kHz
V_Tx-en = 0 V, f = 132 kHz
Fig. Note
1
1
2
2, 3, 4
1
2
5, 13
6, 14 3
Notes:
1. Threshold of falling V_CC2 with hysteresis of 0.15 V (typ.).
2. Threshold of rising junction temperature with hysteresis of 15°C (typ.).
3. IMRR is defined as the ratio of the signal gain (measured at Rx-PD-out with signal applied to Rx-in) to the isolation mode gain (measured at Rx-PD-out
with Rx-in connected to GND2 and the isolation mode voltage, V_IM, applied between GND1 and GND2), expressed in dB.
7