HCPL-810J Datasheet, PDF (6/16 Pages) Agilent(Hewlett-Packard) – PLC Powerline DAA IC

Insulation and Safety Related Specifications
Parameter
Minimum External Air Gap
(Clearance)
Minimum External Tracking
(Creepage)
Minimum Internal Plastic Gap
(Internal Clearance)
Symbol
L(101)
L(102)
Value
8.3
8.3
0.5
Tracking Resistance
(Comparative Tracking Index)
Isolation Group
CTI
>175
IIIa
Unit Condition
mm Measured from input terminals to output terminals,
shortest distance through air.
mm Measured from input terminals to output terminals,
shortest distance path along body.
mm Through insulation distance of conductor to
conductor, usually the straight-line distance
between the emitter and detector.
Volts DIN IEC 112/VDE 0303 Part 1
Material Group (DIN VDE 0110, 1/89, Table 1)
Absolute Maximum Ratings
Parameter
Storage Temperature
Ambient Operating Temperature
Junction Temperature
Supply Voltage 1
Supply Voltage 2
Transmit Output Voltage
Transmit Input Signal Voltage
Transmit Enable Voltage
Receiving Input Signal Voltage
Control-Side Power Dissipation
Line-Side Power Dissipation
Solder Reflow Temperature Profile
Symbol
Min.
Max.
Unit
T_S
−55
125
°C
T_A
−40
85
°C
T_J
125
°C
V_CC1
−0.5
5.5
V
V_CC2
−0.5
5.5
V
V_Tx-out
−0.5
V_CC2
V
V_Tx-in
−0.5
V_CC1
V
V_Tx-en
−0.5
V_CC1
V
V_Rx-in
−0.5
V_CC2
V
P_I
200
mW
P_O
1000
mW
(See Solder Reflow Temperature Profile Section)
Note
1
Notes:
1. Maximum power dissipation in Control side and Line side IC's needs to be limited to ensure that their respective junction temperature is less than 125°C.
The maximum permissible power dissipation is dependent on the thermal impedance and the ambient temperature. Details on the typical thermal
impedances are given in the Package Characteristics. Further details on applying this to an actual application can be found in the Application Information
section under Thermal Considerations.
Recommended Operating Conditions
Parameter
Symbol Min.
Typ.
Max.
Unit
Note
Ambient Operating Temperature
Input Supply Voltage
Output Supply Voltage
Tx-in Signal Current
T_A
−40
V_CC1
4.75
5
V_CC2
4.75
5
I_Tx-in
250
85
°C
5.25
V
5.25
V
µA_PP
1
Notes:
1. The transmitter input impedance is very low, this is meant for signal current input. Transmitter performance is optimized at 250 µA_PP input signal, an
external series resistor with nominal value of 2 kΩ would be required if the input signal is 0.5 V_PP.
6