MB82DP02183C-65L Datasheet, PDF (7/32 Pages) Fujitsu Component Limited. – 32M Bit (2 M word × 16 bit) Mobile Phone Application Specific Memory

MB82DP02183C-65L
■ ABSOLUTE MAXIMUM RATINGS
Parameter
Value
Symbol
Unit
Min
Max
Voltage of VDD Supply Relative to VSS
VDD
− 0.5
+ 3.6
V
Voltage at Any Pin Relative to VSS
VIN, VOUT
− 0.5
+ 3.6
V
Short Circuit Output Current
IOUT
− 50
+ 50
mA
Storage Temperature
TSTG
− 55
+ 125
o_C
WARNING: Semiconductor devices can be permanently damaged by application of stress (voltage, current,
temperature, etc.) in excess of absolute maximum ratings. Do not exceed these ratings.
■ RECOMMENDED OPERATING CONDITIONS
Parameter
Value
Symbol
Unit
Min
Max
VDD (31)
3.1
3.5
V
Supply Voltage*^1, *²
VDD (26)
2.6
3.1
V
VSS
0
0
V
High Level Input Voltage *^1, *^2, *³
VIH (31)
VIH (26)
VDD × 0.8 VDD + 0.2 ( ≤ 3.6)
V
VDD × 0.8
VDD + 0.2
V
Low Level Input Voltage *^1, *⁴
VIL
− 0.3
VDD × 0.2
V
Ambient Temperature
TA
− 30
+ 85
°C
*1 : All voltages are referenced to VSS.
*2 : This device supports both VDD(31) and VDD(26) voltage ranges on identical device. VDD range is divided into two
ranges as VDD(31) and VDD(26) on the table due to VIH varied according to VDD supply voltage.
*3 : Maximum DC voltage on input and I/O pins are VDD + 0.2 V. During voltage transitions, inputs may overshoot
to VDD + 1.0 V for periods of up to 5 ns.
*4 : Minimum DC voltage on input or I/O pins are -0.3 V. During voltage transitions, inputs may undershoot VSS to
-1.0 V for periods of up to 5 ns.
WARNING: The recommended operating conditions are required in order to ensure the normal operation of the
semiconductor device. All of the device’s electrical characteristics are warranted when the device is
operated within these ranges.
Always use semiconductor devices within their recommended operating condition ranges. Operation
outside these ranges may adversely affect reliability and could result in device failure.
No warranty is made with respect to uses, operating conditions, or combinations not represented on
the data sheet. Users considering application outside the listed conditions are advised to contact their
FUJITSU representatives beforehand.
■ PACKGE CAPACITANCE
Parameter
Address Input Capacitance
Control Input Capacitance
Data Input/Output Capacitance
Symbol Test conditions
Min
CIN1
VIN = 0 V
⎯
CIN2
VIN = 0 V
⎯
CI/O
VIO = 0 V
⎯
(f = 1 MHz, TA = +25 °C)
Value
Typ
Unit
Max
⎯
5
pF
⎯
5
pF
⎯
8
pF
7