K10P81M72SF1 Datasheet, PDF (59/73 Pages) Freescale Semiconductor, Inc – K10 Sub-Family

Peripheral operating requirements and behaviors
6.8.6 I2S/SAI Switching Specifications
This section provides the AC timing for the I2S/SAI module in master mode (clocks are
driven) and slave mode (clocks are input). All timing is given for noninverted serial clock
polarity (TCR2[BCP] is 0, RCR2[BCP] is 0) and a noninverted frame sync (TCR4[FSP]
is 0, RCR4[FSP] is 0). If the polarity of the clock and/or the frame sync have been
inverted, all the timing remains valid by inverting the bit clock signal (BCLK) and/or the
frame sync (FS) signal shown in the following figures.
6.8.6.1 Normal Run, Wait and Stop mode performance over the full
operating voltage range
This section provides the operating performance over the full operating voltage for the
device in Normal Run, Wait and Stop modes.
Table 41. I2S/SAI master mode timing in Normal Run, Wait and Stop modes
(full voltage range)
Num.
S1
S2
S3
S4
S5
S6
S7
S8
S9
S10
Characteristic
Operating voltage
I2S_MCLK cycle time
I2S_MCLK pulse width high/low
I2S_TX_BCLK/I2S_RX_BCLK cycle time (output)
I2S_TX_BCLK/I2S_RX_BCLK pulse width high/low
I2S_TX_BCLK/I2S_RX_BCLK to I2S_TX_FS/
I2S_RX_FS output valid
I2S_TX_BCLK/I2S_RX_BCLK to I2S_TX_FS/
I2S_RX_FS output invalid
I2S_TX_BCLK to I2S_TXD valid
I2S_TX_BCLK to I2S_TXD invalid
I2S_RXD/I2S_RX_FS input setup before
I2S_RX_BCLK
I2S_RXD/I2S_RX_FS input hold after I2S_RX_BCLK
Min.
1.71
40
45%
80
45%
—
-1.0
—
0
20.5
0
Max.
3.6
—
55%
—
55%
15
—
15
—
—
—
Unit
V
ns
MCLK period
ns
BCLK period
ns
ns
ns
ns
ns
ns
K10 Sub-Family Data Sheet, Rev. 2, 4/2012.
Freescale Semiconductor, Inc.
59