English
Language : 

33486A Datasheet, PDF (3/30 Pages) Freescale Semiconductor, Inc – Dual High-Side Switch for H-Bridge Applications
TERMINAL CONNECTIONS
TERMINAL CONNECTIONS
GND
1
Cur R
2
IN1
3
GLS1
4
OUT1
5
OUT1
6
OUT1
7
OUT1
8
NC
9
NC
10
VBAT
VBAT
20
WAKE
19
ST
18
IN2
17
GLS2
16
OUT2
15
OUT2
14
OUT2
13
OUT2
12
NC
11
NC
Table 1. TERMINAL DEFINITIONS
Figure 3. 33486A Terminal Locations
Terminal
1
2
3
18
4
17
5–8
9 – 12
13 – 16
19
20
TAB
Terminal Name
GND
Cur R
Formal Name
Ground
Load Current Sense
IN1
Input Channel 1
IN2
Input Channel 2
GLS1
GLS2
OUT1
Gate Low-Side 1
Gate Low-Side 2
Output Channel 1
NC
OUT2
No Connect
Output Channel 2
ST
Status for Both Channels
WAKE
VBAT
Wake
Supply Voltage
Definition
This is the ground terminal of the device.
The Current Sense terminal delivers a ratio amount of the sum of the
high-side currents.
These are the device input terminals that directly control their associated
outputs. Each input terminal has an internal active pull-down so that the
input terminal will not float if disconnected.
Each terminal must be connected to one gate of an external low-side
MOSFET.
Terminals 5, 6, 7, and 8 are the source of the Output Channel 1 15 mΩ
high-side MOSFET1.
These terminals are not used.
Terminals 13, 14, 15, and 16 are the source of the Output Channel 2
15 mΩ high-side MOSFET2.
The status output goes low when a fault mode is detected. It is an open
drain with an internal clamp at 6.0 V. An external pull-up resistor
connected to VDD (5.0 V) is needed.
This logic input enables control of the device. (Wake logic LOW = Sleep
Mode, Wake logic HIGH = full operation.) The WAKE terminal has a pull-
down resistor.
The backside TAB is connected to the power supply of the 33486A.
Analog Integrated Circuit Device Data
Freescale Semiconductor
33486A
3