MC9S08MP16VLF Datasheet, PDF (24/37 Pages) Freescale Semiconductor, Inc – DEMO9S08MP16 User Manual

6.4.2.2
Word Formatted Data
There are three commands which may be accepted. All commands must end
in the special characters #$0D and #$0A which are CR (carriage return) and
LF (line feed). The accepted commands are:
nnnn,nnnn,nnnn,nnnn
The nnnn values are 0000-FFFF and correspond in order to the data
displayed on both the graph and bar graphs as follows: X/A, Y/B, Z/C, W/D.
nnnn:nnnn:nnnn:nnnn
The nnnn values are 0000-FFFF and correspond in order to the data
displayed the graphing component as follows: X, Y, Z, W.
nnnn=nnnn=nnnn=nnnn
The nnnn values are 0000-FFFF and correspond in order to the data
displayed on the bar graph component as follows: A, B, C, D.
7 JUMPER SETTINGS
7.1
7.1.1
System Power
J3 - Power Source Selection
The MP16 processor may obtain its power from the on-board regulator, USB
port, or through APMOTOR_PORT J2. The on-board regulator obtains its
input from a 2.1mm barrel connector and can regulate the output to 5V. The
power switch K1 selects 5V from the on-board regulator or USB port. The J3
header further selects 5V from the power switch or from the APMOTOR
connector. A jump wire may be used to connect TP1 and Pin 1 of the J3
header if the user wants to provide 5V to the APMOTOR connector.
Selects 5V to supply microcontroller VDD. This is the default setting.
Figure 7-1: VDD_SELECT Option Header (J3)
20
DEMO9S08MP16 User Manual