MC9S08MP16VLF Datasheet, PDF (12/37 Pages) Freescale Semiconductor, Inc – DEMO9S08MP16 User Manual

4.4
4.5
4.5.1
• DEMO9S08MP16 User Manual (this document)
• DEMO9S08MP16 Board Schematics
• DEMO9S08MP16 Component Breakdown List
• P&E Embedded Multilink Toolkit PC Applications
• P&E Evaluation Software
• Links to Freescale documentation, P&E Discussion Forums, and
DEMO9S08MP16 FAQs.
Quick Startup
Only a few steps are required to get the DEMO9S08MP16 up and running.
Please reference the Quick Start Guide.
Hardware Setup
First-Time Connection
The DEMO9S08MP16 may be connected to a PC through a USB port.
Connection steps are listed below in typical order:
1. Install the required software, as described in the previous section.
2. Make sure the power switch for USB_PWR for VDD_SEL is installed.
3. Plug the USB cable A-M connector into a free USB port of the PC.
4. Plug the USB cable B-M connector into the USB connector on the
DEMO9S08MP16 Base Board.
5. The operating system will recognize P&E’s Embedded Multilink cir-
cuitry and P&E’s USB to Serial circuitry. Depending on the operating
system, you may see the “Found New Hardware Wizard” dialog to
assist you with software installation for “PEMicro USB Multilink (i0).”
On Windows XP (SP2), the following dialog will appear:
8
DEMO9S08MP16 User Manual