MC9S08MP16VLF Datasheet, PDF (21/37 Pages) Freescale Semiconductor, Inc – DEMO9S08MP16 User Manual

6.4.1
paused and the scale of the X and Y axes can be changed via a tool bar
located in the top right corner of the Serial Grapher Application.
All data to be displayed must be in hexadecimal format. The data can be
accepted and displayed either as incoming byte values ($00-$FF) or word
values ($0000-$FFFF). The data format indicates whether the data is byte or
word data. The graphical components automatically size their range
depending upon the incoming data.
This PC-based application is included on the DVD-ROM that accompanies
the DEMO9S08MP16 and may also be found at:
http://www.pemicro.com/fixedlinks/demotoolkit.cfm.
Visual Components
The Bar Graph has four separate bars A, B, C, and D. On each bar a
percentage value is displayed which indicates the current value relative to the
full range. A byte value of $7F (max is $FF) would show up as approximately
50% as would a word value of $7FFF (max is $FFFF). As can be seen in the
data formatting section, all four bars must be written at the same time. The
bars are shown here:
DEMO9S08MP16 User Manual
17