MC9S08MP16VLF Datasheet, PDF (19/37 Pages) Freescale Semiconductor, Inc – DEMO9S08MP16 User Manual

Figure 6-2: Terminal Application
The terminal window may be set for full duplex or half duplex. In full duplex
mode, only received characters are displayed in the terminal window. In half
duplex mode, both transmitted and received characters are displayed.
To start using this application, please choose COM or virtual USB COM
settings from the drop down Port menu. This specifies the port on the
evaluation board that will be used for serial data transmission. Please make
sure that the jumpers on header J4 are set accordingly. Prior to starting serial
data capture, please specify the Baud, Parity and Bits settings to reflect the
parameters at which your serial communication interface is operating. Once
your port settings are configured, please plug a USB or DB9 serial cable into
the evaluation board and click on the Open Serial Port button.
This PC-based application is included on the DVD-ROM that accompanies
the DEMO9S08MP16, and may also be found at:
http://www.pemicro.com/fixedlinks/demotoolkit.cfm.
6.3
DEMO9S08MP16 Unsecure Application
This application allows secure CFV1 and HCS08 microcontrollers to be
unsecured. The Unsecure application will erase a secure device to make it
unsecure. This application works with the DEMO9S08MP16 board as well as
other user hardware connected to the PC via the USB Multilink or Cyclone
PRO hardware interfaces.
DEMO9S08MP16 User Manual
15