RHFAC14K01V Datasheet, PDF (9/24 Pages) List of Unclassifed Manufacturers – STANDARD MICROCIRCUIT DRAWING

TABLE I. Electrical performance characteristics - Continued.
5/ The V_OH and V_OL tests shall be tested at V_CC = 3.0 V and 4.5 V. The V_OH and V_OL tests are guaranteed, if not tested, for
other values of V_CC. Limits shown apply to operation at V_CC = 3.3 V ±0.3 V and V_CC = 5.0 V ±0.5 V. Tests with input
current at +50 mA and –50 mA are performed on only one input at a time with duration not to exceed 10 ms. Transmission
driving tests may be performed using V_IN = V_CC or GND. When V_IN = V_CC or GND is used, the test is guaranteed for V_IN =
V_IH minimum and V_IL maximum.
6/ The maximum limit for this parameter at 100 krads (Si) is 4 µA.
7/ Power dissipation capacitance (C_PD) determines both the power consumption (P_D) and dynamic current consumption (I_S).
Where:
P_D = (C_PD + C_L) (V_CC x V_CC)f + (I_CC x V_CC)
I_S = (C_PD + C_L) V_CCf + I_CC
For both P_D and I_S, f is the frequency of the input signal and C_L is the external output load capacitance.
8/ Tests shall be performed in sequence, attributes data only. Functional tests shall include the truth table and other logic
patterns used for fault detection. The test vectors used to verify the truth table shall, at a minimum, test all functions of
each input and output. All possible input to output logic patterns per function shall be guaranteed, if not tested, to the truth
table in figure 2 herein. Functional tests shall be performed in sequence as approved by the qualifying activity on qualified
devices. Allowable tolerances in accordance with MIL-STD-883 for the input voltage levels may be incorporated. For
output measurements, H ≥ 0.7V_CC, L ≤ 0.3V_CC.
9/ The AC limits at V_CC = 5.5 V are equal to the limits at V_CC = 4.5 V and guaranteed by testing at V_CC = 4.5 V. The AC limits
at V_CC = 3.6 V are equal to the limits at V_CC = 3.0 V and guaranteed by testing at V_CC = 3.0 V. Minimum AC limits for
V_CC = 5.5 V and V_CC = 3.6 V are 1.0 ns and guaranteed by guardbanding the V_CC = 4.5 V and V_CC = 3.0 V minimum limits,
respectively, to 1.5 ns. For propagation delay tests, all paths must be tested.
STANDARD
MICROCIRCUIT DRAWING
DEFENSE SUPPLY CENTER COLUMBUS
COLUMBUS, OHIO 43218-3990
DSCC FORM 2234
APR 97
SIZE
A
REVISION LEVEL
B
5962-87624
SHEET
9